Ge JAS02SNSS Manuel d'utilisateur télécharger pdf (Page 32)

32

Installation Instructions

ELECTRICAL CONNECTIONS (CONT.)

3

POWER CORD AND STRAIN RELIEF

INSTALLATION

A

Remove the wire cover (on the back of the

range) by removing two (2) screws using a

Phillips screw driver.

Do not discard these screws.

B

Remove the knockout ring (1 3/8”) located on

bracket directly below the terminal block. To

remove the knockout, use a pair of pliers to

bend the knockout ring away from the bracket

and twist until ring is removed.

C

For power cord installations only (see the

next step if using conduit), assemble the strain

relief in the hole. Insert the power cord

through the strain relief and tighten. Allow

enough slack to easily attach the cord

terminals to the terminal block. If tabs are

present at the end of the winged strain relief,

they can be removed for better fit.

NOTE: Do not install the power cord without

a strain relief. The strain relief bracket

should be installed before reinstalling the

rear range wiring cover.

Skip to Step 4 or 5.

D

For conduit installations only, purchase a

squeeze connector matching the diameter of

your conduit and assemble it in the hole. Insert

the conduit through the squeeze connector and

tighten. Allow enough slack to easily attach the

wires to the terminal block.

NOTE: Do not install the conduit without a

squeeze connector. The squeeze connector

should be installed before reinstalling the rear

range wiring cover.

Skip to Step 6 or 7.

Squeeze

connector

T

erminal

block

Conduit

Bracket

GROUND

Wire cover

2 screws

to remove

wire cover

Back of Range

Knockout ring

in bracket

Knockout

ring removed

Terminal block

(appearance

may vary)

Power cord

Strain relief

Terminal

block

Bracket

GROUND

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 87 88

Commentaires sur ces manuels

Pas de commentaire