GE LMAB1240ST Manuel d'utilisateur Page 17

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 35
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 16
H. HIGH VOLTAGE TRANSFORMER
REMOVAL
1) Discharge the high voltage capacitor.
2) Disconnect the lead wire from magnetron, high
voltage transformer, and capacitor.
3) Remove the screw holding the high voltage
transformer to the baseplate.
I. FAN MOTOR ASSEMBLY REMOVAL
1) Discharge the high voltage capacitor.
2) Disconnect the lead wire from fan motor and high
voltage capacitor.
3) Remove the screws holding the the suction guide
ASSEMBLY to the oven cavity.
4) Remove the two screws holding the fan motor
ASSEMBLY to the suction guide ASSEMBLY.
J. HIGH VOLTAGE CAPACITOR AND
DIODE REMOVAL
1) Discharge the high voltage capacitor.
2) Disconnect the lead wire from fan motor and high
voltage capacitor.
3) Remove the screw holding the suction guide
ASSEMBLY to the oven cavity.
4) Remove the screw holding the high voltage capacitor
bracket and remove the high voltage diode earth
screw.
K. IINTERLOCK SYSTEM
1) INTERLOCK MECHANISM
The door lock mechanism is a device which has
been specially designed to eliminate completely
microwave activity when the door is opened during
cooking and thus to prevent the danger resulting
microwave leakage.
2) MOUNTING OF THE PRIMARY/MONITOR/
SECONDARY SWITCHES TO THE LATCH
BOARD
3) INSTALLATION AND ADJUSTMENT OF THE
LATCH BOARD TO THE OVEN ASSEMBLY
Mount the latch board to the oven assembly.
Adjust the latch board so that oven door will not
have any play in it when the door is closed.
Tighten the mounting screw.
Check for play in the door by pushing the door
release button. Door movement should be less
than 0.5 mm. (1/64 inch)
Don't push the door release button while making this
adjustment. Make sure that the latch moves
smoothly after adjustment is completed and that the
screws are tight. Make sure the primary, monitor,
and secondary switches operate properly by
following the continuity test procedure.
5-6
H.V.
Transformer
Suction
Guide
Noise Filter
H.V.
Diode
H.V.
Capacitor
Fan Motor
PRIMARY
SWITCH
ADJUSTMENT
DIRECTION
MONITOR
SWITCH
SECONDARY
SWITCH
Vue de la page 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 34 35

Commentaires sur ces manuels

Pas de commentaire