GE LMAB1240ST Manuel d'utilisateur télécharger pdf (Page 19)

5-8

COMPONENT TEST PROCEDURE

CAUTIONS

1. DISCONNECT THE POWER SUPPLY CORD FROM THE OUTLET WHENEVER REMOVING THE

OUTER CASE FROM THE UNIT. PROCEED WITH THE TEST ONLY AFTER DISCHARGING THE HIGH

VOLTAGE CAPACITOR AND REMOVING THE WIRE LEADS FROM THE PRIMARY WINDING OF THE

HIGH VOLTAGE TRANSFORMER. (SEE PAGE 2-1)

2. ALL OPERATIONAL CHECKS WITH MICROWAVE ENERGY MUST BE DONE WITH A LOAD (1 LITER

OF WATER IN CONTAINER) IN THE OVEN.

COMPONENTS TEST PROCEDURE RESULTS

HIGH VOLTAGE

TRANSFORMER

(Wire leads removed)

MAGNETRON

(Wire leads removed)

1. Measure the resistance.

(Ohm-meter scale: Rx1 and Rx100)

• Primary winding

• Secondary winding

• Filament winding

2. Measure the resistance.

(Ohm-meter scale: Rx1000)

• Primary winding to ground

• Filament winding to ground

1. Measure the resistance.

(Ohm-meter scale: Rx1)

• Filament terminal

2. Measure the resistance.

(Ohm-meter scale: Rx1000)

• Filament to chassis

Approx.: 0.2 ~ 0.4 ohm

Approx.: 60 ~ 90 ohm

Less than: 1 ohm

Normal: Infinite

Normal: Less than 1 ohm

Normal: Infinite

FILAMENT

WINDING

PRIMARY

TERMINAL

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 34 35

Pas de commentaire

GE LMAB1240ST Manuel d'utilisateur Page 19