GE JGBS24 Manuel d'utilisateur télécharger pdf (Page 38)

WHEN ALL HOOKUPS ARE

COMPLETED

Make sure all controls are left in the OFF

position. Make sure the flow of combustion

and ventilation air to the range is

unobstructed.

CONVERT TO NATURAL GAS

(or convert

back to LP gas from natural gas)

This range leaves the factory set for use

with LP gas. If you want to convert to natural

gas, the conversion must be performed by a

qualified gas installer.

The conversion instructions and natural gas

orifices can be found attached to the range

next to the pressure regulator.

Keep these instructions and the orifices in

case you want to convert back to LP gas.

Installation Instructions

INSTALL THE ANTI-TIP DEVICE

(cont.)

For wood construction, drill a pilot hole

at an angle of 20° from the horizontal.

A nail or awl may be used if a drill is not

available.

Mount the Anti-Tip device with the screw

provided.

For cement or concrete construction,

you will need a 1/4″ x 1

1

⁄2″ lag bolt and

a 1/2″ O.D. sleeve anchor, which are not

provided. Drill the recommended size

hole for the hardware.

Install the sleeve anchor into the drilled

hole and then install the lag bolt through

the device. The bolts must be properly

tightened as recommended for the

hardware.

Slide the range against the wall, and

check for proper installation by grasping

the front edge of the cooktop and

carefully attempting to tilt the range

forward. The bracket should stop the

range within 4 inches. If it does not,

the bracket must be reinstalled.

E

D

7

Back of

range

Wallboard

Wood screw

Anti-Tip

device

38

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44

Commentaires sur ces manuels

Pas de commentaire