GE PT9050SFSS Manuel d'instructions Page 7

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 16
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 6
10
MOUNT THE OVEN
WARNING
:
Mounting screws must
be used. Failure to do so could result in the oven
falling out of the cabinet, causing serious injury.
NOTE: Before drilling the pilot holes, make sure the
oven is pushed as far back into the opening as it will
go and is centered.
NOTE: If the cabinet is particle board, you must use
#8 x ¾” particle board screws. These may
be purchased at any hardware store.
A. Drill through the mounting holes (top and bottom)
of the side trim for the #8 mounting screws
provided.
B. Secure the oven cabinet with the screws provided.
Mounting
Hole
Locations
(hole locations
may vary)
11
BOTTOM TRIM INSTALLATION
With oven installed, attach the bottom trim through its mounting holes in front vertical brace using
two trim screws provided. Bottom trim lip must be placed under flange of bottom air duct.
IMPORTANT: If this unit is ever removed from the cabinet or the oven is ever pulled out for service,
the bottom trim must be removed first or damage to the trim will occur.
The Screws
Must Be a
Minimum of
1/4” (6 mm)
From the
Front of
the Cutout.
SWO’s and DWO installations without pedestal
DWO’s with pedestals
Vue de la page 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Commentaires sur ces manuels

Pas de commentaire