Ge ZICP360NXRH Manuel d'utilisateur télécharger pdf (Page 15)

STEP 9 INSTALL 1/4” FRAMED PANELS

• There are two sets of holes in the handle side trim.

Replace handle side trim by installing the original screws

in the FRONT screw holes.

• Secure the handle to the door using the REAR screw

holes.

• Follow the same procedures to install the drawer panel.

Right hand models shown. Use the same instructions

for left hand models.

IF YOU ARE INSTALLING OVERLAY PANELS,

GO TO STEP 9A.

Install door and drawer panels:

• Open door to 90°. Remove the 4 Phillips head screws

from the door handle.

• Remove handle. Retain all screws.

• Remove 4 screws holding trim, lift off trim.

Retain screws.

• Slide framed panel into the door trim.

Standard supplied handle shown

in 1/4” panel position.

Installation Instructions

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Ge ZICP360NXRH Manuel d'utilisateur Page 15