Ge ZICP360NXRH Manuel d'utilisateur télécharger pdf (Page 16)

STEP 9A INSTALL OVERLAY PANELS

• There are two sets of holes in the handle side trim.

Replace handle side trim by installing the original screws

in the REAR screw holes.

• Secure the handle to the door using the FRONT

screw holes.

• Follow the same procedures to install the drawer panel.

Custom handles

If you are using custom handles, the handle must be

properly secured to the panel before sliding the panel

into the trim.

• The cabinet manufacturer will supply the custom

handle and hardware.

• Secure the door/drawer trim using both the FRONT

and REAR screw holes. Discard supplied handle.

Right hand models shown. Use the same instructions

for left hand models.

Install door and drawer panels:

• Open door to 90°. Remove the 4 Phillips head screws

from the door handle.

• Remove handle. Retain all screws.

• Remove 4 screws holding trim, lift off trim.

Retain screws.

• Slide overlay panel into the door trim.

Supplied handle shown in the

overlay panel position.

Use Rear Holes

to Secure Trim

Use Front Hol

to Secure Han

Installation Instructions

1 2 ... 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Ge ZICP360NXRH Manuel d'utilisateur Page 16