Ge PGP953DETWW Manuel d'utilisateur télécharger pdf (Page 9)

GEAppliances.com

A

CAUTION:

DO NOT OPERATE ^ BURNER

WITHOUT ALL BURNER PARTS

IN PLACE.

Burner Caps and Heads

Turn all controls off before removing burner

parts.

NOTE: Before removing the burner cops

and heads, remember their size and

location. Replace them in the same

location after cleaning.

The burner assemblies should always be

kept clean. Spillovers should be cleaned

immediately; they can clog the openings in the

burner assemblies.

Remove the burner grates, burner caps and

burner heads for easy cleaning.

Wash burner caps and burner heads in hot,

soapy water and rinse with clean running

water. You may scour with a plastic scouring

pad to remove burned-on food particles.

Use a sewing needle or twist tie to unclog the

small holes in the burner head, if required.

To remove burned-on food, soak the burner

heads in a solution of mild liquid dishwashing

detergent and hot water for up to 20-30

minutes, if required. For more stubborn stains,

use a toothbrush.

If the spill went inside the burner head

assembly, wash it under running water. Shake

to remove any excess water. Air dry and make

sure the small ignitor holes are open.

NOTES:

■ Do not wash any burner parts in a

dishwasher.

■ Do not use steel wool or scouring powders

to clean the burners.

Burner Bases

The burner bases can not be removed for

cleaning.

To clean the burner bases, refer to the Porcelain

Enamel Surfaces or Stainless Steel Surfaces

section, depending on your model.

Make sure that no water gets into the burner

bases and the brass gas orifices.

Wipe clean with a damp cloth. Allow them to

dry fully before using.

Tri-ring base

(on some models)

Electrodes

The electrode of the spark igniter is exposed

beyond the surface of the burner base. When

cleaning the cooktop, be careful not to snag the

electrode of the spark igniter with your cleaning

cloth. Damage to the igniter could occur.

Be careful not to push in any cooktop controls

while cleaning the cooktop. A slight electrical

shock might result which could cause you to

knock over hot cookware.

Make sure that the white ceramic electrodes

in the cooktop are clear of soil and dry. Clean

the metal part of the electrode with a soft cloth.

For stubborn, hardened soil, clean the metal

portion of the electrode with an emery board.

Do not clean the white ceramic portion of the

electrode with the emery board. It is acceptable

to clean the white portion of the electrode with

a soft cloth, but not with an emery board.

Before reassembling the surface burners, push

down on each of the white ceramic electrodes

to make sure they are pressed against the

burner bases.

NOTE: Do not attempt to remove the electrode

from the cooktop or any screws from the burner

head or burner base.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 47 48

Commentaires sur ces manuels

Pas de commentaire