Ge PGP959SETSS Manuel d'utilisateur télécharger pdf (Page 15)

Installation Instructions

MAKING THE LP CONVERSION (CONT.)

ADJUST BURNER FLAMES

H Turn all burners full on and check the flames.

They should be blue in color with some yellow

tipping at the ends of the flame. Foreign

particles in the gas line may cause on orange

flame at first, but this will soon disappear.

E Turn the cooktop burner knob to the lowest

setting while observing the flame.

Adjust the low flame setting using the valve bypass

screw as follows:

Low-setting adjustments must be made with two

other burners in operation on a medium setting.

This prevents the low flame from being set too low,

resulting in the flame being extinguished when

other burners are turned on.

E To adjust the flame,

remove the knobs. Use

screwdriver to remove

valve stem plugs as

shown.

Insert a screwdriver

through the access hole

in valve switch. Engage

adjustment screw in

valve. Refer to the

illustration below that

matches the adjustment

screw location for

your model. The

griddle burner (PGP959

and CGP350) has 2

adjustment screws,

one for the left rear

burner and one for the

left front burner during

griddle control. Griddle

control must be turned

to LO when making this

adjustment.

• If the flames were too

small or fluttered, open

the valve more than the original setting.

• If the flames blew away from the burner,

close the valve more than the original

setting.

E Make the adjustment by slowly turning the

screw until flame appearance is correct.

Left of stem

For leftfrontgriddle

burner and tri-ring

burner simmer

adjustment screw

For all burners

except tri-ring

E Testing Flame Stability:

Test 1 - Temporarily replace knobs. Turn the

knob from "HI" to the lowest setting

quickly. If the flame goes out at the

lowest setting, increase the flame size

and test again.

Test 2 - With the burner on the lowest setting,

open and close the cabinet door

under the cooktop. If the flame is

extinguished by the air currents

created by the door movement,

increase the flame height and test

again.

E Flame Recheck:

After the adjustment is made, turn all burners off.

Ignite each burner individually. Observe the flame

at the "HI" position. Rotate the valve to the lowest

setting and be sure that the flame size decreases

as the valve is rotated counterclockwise.

TO CONVERT THE COOKTOP BACK TO NATURAL

GAS, REVERSE THE STEPS UNDER MAKING THE LP

CONVERSION.

Once the conversion is complete and checked ok,

replace valve stem plugs and knobs, and fill out

the LP sticker. Include your name, organization and

date conversion was made. Apply the sticker near

the cooktop gas inlet opening to alert others in

the future that this appliance has been converted

to LP gas. If converting back to natural gas from

LP, please remove the sticker so others know the

appliance is set to use natural gas.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Ge PGP959SETSS Manuel d'utilisateur Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Poêles Ge PGP959SETSS