Ge AEE08AR Manuel d'utilisateur télécharger pdf (Page 5)

GEAppliances.com

Heat Mode

Use the Heat mode at Low, Med, High or Auto Fan

Speed for heating. Use the Temperature increase A

/ Decrease T pads to set the desired temperature

between 61°F and 86°F in 1°F increments.

An electronic thermostat is used to maintain the room

temperature. The heater will cycle on and off to keep the

room at the set level of comfort.

Cool Mode

Use the Cooi mode at Low, Med, High or Auto Fan

Speed for cooling. Use the Temperature increase A

/ Decrease T pads to set the desired temperature

between 61°F and 86°F in 1°F increments.

An electronic thermostat is used to maintain the room

temperature. The compressor will cycle on and off

to keep the room at the set level of comfort. Set the

thermostat at a lower number and the indoor air will

become cooler. Set the thermostat at a higher number

and the indoor air will become warmer.

NOTE: If the air conditioner is off and is then turned on

while set to a Cool setting or if turned from a fan setting

to a Cool setting, it may take approximately 3 minutes

for the compressor to start and cooling to begin.

Cooling Descriptions

For Normal Cooling—Select the Cool mode and High or

Med fan with a middle set temperature.

For Maximum Cooling—Select the Cool mode and High

fan with a lower set temperature.

For Quieter and Nighttime Cooling—Select the Cool

mode and Low fan with a middle set temperature.

Energy Saver Mode

Controls the fan.

ON—The fan will cycle on and off with the compressor.

This results in wider variations of room temperature and

humidity. Normally used when the room is unoccupied.

NOTE: The fan may continue to run for a short time after

the compressor cycles off.

OFF—The fan runs all the time, while the compressor

cycles on and off.

Fan Only Mode

Use the Fan Only Mode at Low, Med or High fan speed

to provide air circulation and filtering without cooling.

Since fan-only settings do not provide cooling, a Set

temperature cannot be entered. The room temperature

will appear in the display.

NOTE:Auto Fan Speed cannot be used when in the Fan

Only Mode.

Auto Fan Speed

Set to Auto fan speed for the fan speed to

automatically set to the speed needed to provide

optimum comfort settings with the set temperature.

If the room needs more cooling, the fan speed will

automatically increase. If the room needs less cooling,

the fan speed will automatically decrease.

NOTE: Auto Fan Speed cannot be used when in the Fan

Only Mode.

Remote Control

■ To ensure proper operation, aim the remote control

at the signal receiver on the air conditioner.

■ Make sure nothing is between the air conditioner

and the remote control that could block the signal.

■ The remote control signal has a range of

up to 20 feet.

■ Make sure batteries are fresh and installed correctly

as indicated on the remote control.

■ Remote contains a magnet allowing it to attach to

metal surfaces.

Power Outage Recovery Feature

In the case of a power outage or interruption, the unit

will automatically re-start in the settings last used after

the power is restored. If the Delay l-24hr feature was

set, it will resume countdown. You may need to set a

new time if desired.

1 2 3 4 5 6 7 8 9 10 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Ge AEE08AR Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Adoucisseurs Ge AEE08AR