Ge 164D4290P393 Manuel d'utilisateur télécharger pdf (Page 12)

REMOVE DUCT KNOCKOUT

If recirculating, non-vented ductless (JN327 and RN328,

and optional for JV347 and JV367 models only), skip to

Step 10 D and proceed.

Using a flat blade screwdriver, remove the appropriate

duct knockout from the top or back of the hood.

⁄4″ x 10″ Rectangular

vertical discharge.

Remove top rectangular

duct knockout only.

7″ Round vertical

discharge. Remove circular

duct knockout only.

⁄4″ x 10″ Rectangular

horizontal discharge. Remove

rear rectangular duct knockout only.

FOR 3

⁄4″ X 10″ RECTANGULAR

DUCTED DISCHARGE

INSTALLATIONS ONLY:

Attach exhaust adaptor/damper over the appropriate

knockout opening (for vertical or horizontal,

depending on installation) with two exhaust adaptor

screws. Make sure damper pivot is nearest to top/back

edge of hood. Remove tape from damper flap.

Up to 1″ side-to-

side adjustment

Tape

Top/back edge

Exhaust adaptor/damper

(vertical discharge position)

Pivot

(depending on

installation)

FOR 7″ ROUND VERTICAL

DUCTED DISCHARGE

INSTALLATIONS ONLY:

Bend up the duct alignment ears in preparation for

later attachment of the 7″ duct.

Installation Instructions

NOTE: The exhaust adaptor/damper can be installed

up to 1 inch on either side of the hood center to

accommodate off-center ductwork. In extreme off-

center installations, one end of the duct connector may

need to be trimmed to clear the electrical cable clamp.

Exhaust adaptor/damper

(horizontal discharge position)

Attachment ear tabs

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Ge 164D4290P393 Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Ventilateurs Ge 164D4290P393