GE DMA DMS & DMY Guide d'installation télécharger pdf

GEH-5729D

INSTRUCTIONS

Dimension

DMA (Arm)

READ THOROUGHLY BEFORE INSTALLING

GENERAL

This luminaire is designed for outdoor lighting applications, and

should not be used in areas of limited ventilation, or in high

ambient temperature enclosures; it should be installed and

maintained according to following recommendations.

UNPACKING

This luminaire has been properly packed so that no parts should

have been damaged during transit. Inspect to confirm.

INSTALLATION

Reflector Rotation: Reflectors may be rotated such that socket

is in any of four positions. This allows for variations in beam aiming.

In order to rotate the reflector the following procedure should be

followed.

1. Rotation is best accomplished before mounting the luminaire

on pole.

2. Note the rear edge of reflector position with respect to hinges

(edge inserted into hinge pocket). Access reflector by loosening

reflector plate to main housing screw and allowing reflector

plate assembly to lie on door assembly. It is not necessary to

detach tether.

3. Remove four screws which attach reflector to reflector plate.

4. Rotate reflector to desired position, being careful not to twist

socket lead wires. For type VT3, do not aim street side toward

the pole.

5. Reattach reflector by re-inserting four screws.

6. Reposition reflector plate by inserting rear edge of plate into

hinge pocket and attach plate to main housing with screw.

MOUNTING

NOTE: Power leads should be pulled as mounting parts are

assembled, verifying that leads are free and not pinched.

Ballast voltage selection is best accomplished before mount-

ing luminaire. See Wiring for instruction.

A. ARCHITECTURAL MOUNTING:

(Arm)

1. Install nut plate inside pre-drilled pole with nuts to inside.

Secure with screw provided.

2. Install the two (2) studs ensuring that they fully penetrate the

nuts on the nut plate.

3. Align upper and lower guides on inside of mounting arm with

their respective studs and slide it into place against pole.

4. Open luminaire door by pushing inward on latches while

supporting door. Release reflector plate by loosening plate

main housing screw and allow plate to hang from tether.

5. Install the luminaire and secure with flat washers and locknuts

provided. Align the system as the nuts are tightened.

CAUTION: Ensure that nuts fully engage the two studs.

Correct tightening of stud nuts is important to ensure proper

function of mounting system. Torque nuts to 18-22 foot

pounds.

CAUTION

Unit will fall if not installed properly

• Follow installation instructions

WARNING

Risk of electric shock

• Turn power off before servicing

– see instructions

These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in connection with installation, operation or

maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s purposes, the matter should be referred

to GE Lighting Solutions.

Lighting Solutions

1 2

Résumé du contenu

Page 1 - DMA (Arm)

GEH-5729DINSTRUCTIONSDimensionTM DMA (Arm)READ THOROUGHLY BEFORE INSTALLINGGENERALThis luminaire is designed for outdoor lighting applications, andsho

Page 2 - MAINTENANCE AND CLEANING

35-201578-P4 (1/08)B. OTHER MOUNTINGSExternal Slipfitters, Knuckle Flat Surface, Knuckle Pole Topand Round Pole Adapters are also available for use wi