GE IM4D Manuel d'utilisation et d'entretien Page 12

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 68
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 11
Installation Instructions
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
WARNING
To eliminate the
risk of electric shock or injury during
installation, you must first unplug the
refrigerator before proceeding. Failure
to follow these instructions can result in
electrical shock.
Flat blade and Phillips
screwdrivers
Pliers
TOOLS YOU WILL NEED
Sharp knife
2
SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF. Leave
the power switch in the OFF position until the
refrigerator is connected to the water supply to
prevent premature operation.
PREPARE FOR INSTALLATION
Remove the storage
basket (on some models)
by pulling it out to the
stop position and lifting
it up and out.
Note: After removing
the basket, push the
H[WHQVLRQDUPVEDFN
into the freezer
compartment.
Remove the chiller shelf
(on some models) by
pulling it straight out.
Remove the center
vertical shelf support
(on some models) by
lifting it and rotating
its bottom to the right.
Inside the freezer,
remove the two small
white plug buttons (on
some models) from the
side wall. (If screws are
present instead of plugs,
leave them in place.)
Remove and discard
the large white plug
from the rear freezer
wall.
Remove the outlet cover with a flat-blade
screwdriver.
1
INSTALL THE ICEMAKER FILL CUP
Install the icemaker fill cup (end-mounted) that came
with your unit into the icemaker as shown. If the fill cup
KDVEHHQPLVSODFHGFDOODQGRUGHUSDUW
:5;
4
INSTALL THE MOUNTING SCREWS
Skip to Step 4 if screws are already in place in
the freezer side wall.
Install two self-tapping Phillips
head screwsIURPWKHNLW
in the holes in the side wall.
7KHVFUHZKHDGVVKRXOGH[WHQG
about 1/2" (13 mm) from the side
wall.
3
Power
Switch
(Appearance may vary)
Outlet
cover
Remove side wall
plug buttons or leave
screws in place
Rear wall
plug button
ICEMAKER INSTALLATION INSTRUCTIONS T
12
Vue de la page 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 67 68

Commentaires sur ces manuels

Pas de commentaire