GE PSB48YPHSV Manuel d'instructions télécharger pdf (Page 38)

11A INSTALL DOOR PANELS

Install 1/4” Decorative Panels:

• Remove Pre-Installed Handles

Open door to 90°. Remove 5 Phillips head screws

from the Fresh Food and Freezer door handles;

retain all screws. Lift off pre-installed door handles.

• Install Door Panels

NOTE: Carefully push the Fresh Food panel in until

it slides into the slot behind the trim. Gently push to

opposite side. Repeat procedure for upper and lower

Freezer panels.

• Install Custom Trim

Install the custom trim with the original

5 Phillips head screws. Tighten. Repeat

for Freezer door.

NOTE: Ensure that the edge of the custom trim

does not pinch the door gasket.

• 3/4” Custom Decorative Panels

If you choose to install custom wood panels, they

must be cut to dimensions shown

on pages 23–30. The panels will slide

into the frame on the doors and grille.

If using custom handles, please see Door Handles

on page 20.

IMPORTANT NOTE: Maximum custom panel

thickness must not exceed 1-1/8” thick and 70 lbs for

the Fresh Food door, 45 lbs total for the Freezer door

and 15 lbs for the Grille panel.

Installation Instructions

Fresh Food

Refrigerator

Door

Handle

3/4" Custom Panel

if Required

Custom Trim

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 99 100

Pas de commentaire

GE PSB48YPHSV Manuel d'instructions Page 38