Ge ZV48SSFSS Manuel d'utilisateur télécharger pdf (Page 13)

49-80151-8

Installation Instructions

67(3%$OWHUQDWH0RXQWLQJ0HWKRG

“A” Centerline to Stud

and Keyhole Slots

“B” Hood Width At

the Top

ZV48T 19-9/16" 40"

ZV48S 23-9/16" 47-15/16"

ZV36T 13-9/16" 28"

ZV36S 17-9/16" 35-15/16"

ZV30T 10-9/16" 22"

ZV30S 14-9/16" 29-15/16"

INSTALL HOOD TO SOFFIT OR BENEATH CABINETS

SKIP THIS STEP IF USING WALL MOUNTING METHOD

When necessary, the hood may be installed so that it is

VXSSRUWHGE\WKHVRI¿W

7KHVRI¿WVKRXOGEHFRQVWUXFWHGZLWK[·V

• Determine the installation location on the wall.

• Continue the centerline forward on the bottom of the

FDELQHWRUVRI¿W

• The opening above the hood should allow for the 10"

round duct and clearance to slide the hood back against

the wall.

Requires 10-1/2" Min.

Opening For Ductwork

and Hood Installation

• The 2 x 4 studs must be located as shown in the chart,

Dim. A. to accept mounting screws.

,03257$176RI¿WIUDPLQJPXVWEHFDSDEOHRI

VXSSRUWLQJXSWROEV

• Drill 1/8" pilot holes into the studs at the locations shown

in the top view illustration.

Install Transition Onto Top of Hood

• Place the transition piece over the hood exhaust and

secure with 4 screws provided.

• Use duct tape to seal the connection. Check to be sure the

damper moves freely.

0RXQW+RRGRQWR6RI¿WRU&DELQHW

Note: If mounting to the underside of a cabinet with a

UHFHVVHGERWWRPLQVWDOOVKLPVWR¿OOWKHJDS

Duct

Transition

Top of

Hood

• Drive mounting screws into the studs until they protrude

1/4". The 1/4" gap will provide clearance to engage the

keyhole slots in the top of the hood.

• Lift hood to installation position. Locate house wiring and

route through the knockout (from the back or top of the

hood).

• Lift hood onto mounting screws. Slide back against the

rear wall.

• Tighten mounting screws.

IMPORTANT: For additional support and to

minimize vibration during operation, the hood must

be secured to the back wall. Use wall anchors to

fasten bottom back of hood to the wall.

1/4" Gap

Push Back

to Wall

Add Shims

If Bottom

Is Recessed

Back

Wall

Cabinet

Soffit

Engage Top

Keyhole Slots

7-1/2"

2-9/16"

8-1/8"

Back of Hood

Top View

Front of Hood

IMPORTANT: Remove

shipping tape from

damper and check that

damper moves freely.

1 2 ... 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Ge ZV48SSFSS Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Cagoules Ge ZV48SSFSS