Ge ZV750SPSS Manuel d'utilisateur télécharger pdf (Page 18)

Installation Instructions

INSTALLATION – RECIRCULATING

INSTALL FILTERS

• There are two channels inside the back and front of the

hood. These channels will hold the charcoal filters and

stainless steel grease filters in place.

Install charcoal filters

• Remove protective film on the charcoal filters.

• Tip charcoal filters into the upper (top) channels at the

rear of the opening. Grasp the filter tab, lift and pull

forward until it rests in the front upper channel.

• Install all 3 charcoal filters.

Install grease filters

• Remove protective film from grease filters.

• Tip the grease filter into the lower channel at the

rear of the opening. Push back, lift and pull the knob

forward until the filter rests on the channel.

• Install all 3 grease filters.

• Turn power on. If the filter light on the control panel

glows, adjust the right-side filter in the channel to

engage the switch arm.

Upper charcoal

filter channel

Grasp tab,

lift and pull forward

Lower charcoal

filter channel

Upper charcoal

filter channel

Lower

filter slots



FINALIZE INSTALLATION

• Remove protective film covering the control panel

on the front face of the hood and any remaining

packaging materials.

• Make sure the filters are seated properly when

installed and the filter light is not on.

• Be sure fan and lights operate correctly. Refer to

the Owner’s Manual for operating instructions and

Problem Solver.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 55 56

Pas de commentaire

Ge ZV750SPSS Manuel d'utilisateur Page 18