Ge GMR06AAZBB Manuel d'utilisateur Page 7

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 16
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 6
7
Safety Instructions Operating Instructions Troubleshooting Tips Consumer SupportInstallation Instructions
Defrosting
(on push button defrost models only)
Defrost whenever frost on the wall of the ice tray compartment becomes
1/4 thick.
To defrost:
Remove foods and ice trays from the refrigerator and ice tray
compartment.
Ensure drip tray is below ice tray compartment to collect water.
Push in the red “Defrost Button” located in the center of the
temperature control dial. Defrost cycle will start immediately. NOTE:
Turning the temperature control dial to the OFF position
is not required.
Defrosting usually takes a few hours. When defrosting is complete, the red
“Defrost Button” will release automatically. Then the refrigerator will
resume normal operation while moving towards the set temperature.
NOTE: After defrosting, allow a few hours to reach the set temperature
before making any further adjustments.
To defrost faster, keep the door open. Also, pouring warm (not hot) water
on the frosted part may speed defrosting. Do not use boiling water—it
may damage plastic parts.
CAUTION: If you decide to “speed up” the defrost cycle by manually
removing ice, NEVER use a sharp or metallic instrument to chip away
the ice as it may damage the cooling coils. (A punctured cooling coil will
cause serious problems and void the warranty.) Do no use any electrical
device in defrosting your refrigerator.
After defrosting:
After red “Defrost Button” has released, empty water from the drip
tray. Wash the tray with warm water. Dry the drip tray completely.
Wipe the ice tray compartment with a damp cloth.
Return drip tray to below ice tray compartment.
Return food and ice trays to the refrigerator and close the door.
IMPORTANT: If the red “Defrost Button” is pushed accidentally,
it can not be manually released. The defrost cycle will run until complete.
To speed up the defrost cycle, remove the drip tray and apply a warm
damp cloth against the temperature sensing wire located on the underside
of the ice tray compartment. After several minutes, the heat from the
warm cloth will raise the temperature of the thermostat, causing the
defrost cycle to end and releasing the red “Defrost Button.” The
refrigerator will then resume normal operation.
NOTE: If ice buildup is very thick, it may keep the ice tray compartment door
from opening or closing completely. Don’t try to force it open or closed; after
defrosting, the door will open and close easily.
GEAppliances.com
Defrost push
button
Temperature
sensing wire
Vue de la page 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Commentaires sur ces manuels

Pas de commentaire