Ge 20309 Manuel d'utilisateur télécharger pdf (Page 3)

Battery Installation

1. On the back of the remote, push down on the tab and lift the

cover off.

2. Match the batteries to the + and - marks inside the battery

case, then insert 2 AAA Alkaline batteries.

3. Press the battery cover back into place.

Battery Saver

Your remote automatically turns off if the buttons are depressed

more than 30 seconds. This will save your batteries should your

remote get stuck in a place where the buttons remain depressed

(e.g., between the sofa cushions).

Code Saver

You will have up to 10 minutes to change the batteries in your

remote without losing codes you have programmed. However, do

not press any buttons until batteries are installed in the remote. If

buttons are pressed without batteries in the remote, all codes will

be lost.

Code Setup

The SETUP button is used to setup the remote. You can

either setup the remote using the code for your brand of

product, from the code tables (on separate sheet), or you

can search through the library of codes until you ﬁnd a

code that works for your product. Please refer to “Programming

with Code Search” page 9 for more information on using the code

search feature to learn how to search through the library of codes

for your products. NOTE: You can store any kind of code under any

mode (except TV). I.E. you can store a VCR code under the CBL/SAT

button, or a DVD code under the VCR button, etc. However, you can

only store TV codes under the TV button.

Setup

1 2 3 4 5 6 7 8 ... 15 16

Pas de commentaire

Ge 20309 Manuel d'utilisateur Page 3