Ge PGP966DETBB Manuel d'utilisateur télécharger pdf (Page 14)

Installation Instructions

MAKING THE LP CONVERSION (CONT.)

H CHANGE COOKTOP BURNER

ORIFICES

H Remove the top grates,

burner caps, and burner

heads.

E Remove the spark

igniters from the burner

base (if required to

access the orifices).

Using a No. 15 "Torx"

head driver bit, remove

the screws holding the

burner base in position.

E Using a 7mm nut driver,

remove the top burner

orifices. These may be

accessed through the

hole in the cooktop.

Remove This

y Assembly

Orifice Spud Located

Through This Opening

Burner cap

Burner

head i

Spark igniter

Burner

base

18,000 BTU Burner

(on some models)

Burner

Spark igniter

[El CHANGE COOKTOP BURNER

ORIFICES (CONT.)

Retainer

Ring

On most burners,

the orifices have a spring-

loaded retaining ring around

the hex head to hold the

orifice in the nut driver during

installation and removal. A

slight amount of force is required to push the nut

driver down over the ring.

NOTE: For orifices that do not have a spring-

loaded retaining ring, use pliers to hold the orifice

in position during initial thread (-^

------------------

engagement or final removal to

avoid dropping the orifice in the

cooktop. Then use the nut driver

to tighten or loosen.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Ge PGP966DETBB Manuel d'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Poêles Ge PGP966DETBB