GE ZV830 Manuel d'utilisateur télécharger pdf (Page 10)

Installation Instructions

INSTALL DUCT BRACKET

The duct bracket should be installed against the back wall

and flush with the ceiling. This bracket will hold the duct cover

in place at the top.

Secure the bracket to the wall:

• Align the diamond centerline cutout on the bracket

with the penciled centerline on the wall.

• Mark 2 screw hole locations in the wall.

• Drill 1/8

″ pilot holes in the marked locations.

• If pilot holes do not enter wood studs, enlarge the holes

to 3/8

″ and install metal wall fastener anchors (provided).

• If mounting directly to a masonry wall, obtain appropriate

#10 masonry screw anchors. Drill and install per the

fastener supplier’s instructions.

• Drive screws, by hand, into the fasteners to allow anchors

to expand. Remove the screws.

• Secure the bracket to the wall with wood screws and/or fasteners.

INSTALL HOOD MOUNTING SCREWS

The two upper mounting screws must enter the horizontal

support or wall studs.

• With the template taped in place, use a punch to mark

mounting bracket screw locations.

• Drill 1/8

″ pilot holes in 2 of the punched locations

in the lower bracket.

• Remove the template.

• Install the mounting screws, leave 1/4″ gap between

the screw head and the wall. This will allow the keyhole slot

on the hood frame to engage the screw head.

IMPORTANT: Use the mounting screws provided. DO NOT USE

DRYWALL SCREWS.

• Check to be sure the mounting screws are

horizontally level.

Installation Height

Align Bottom Edge With

Pencil Line Indicating

Bottom of Hood

REAR WALL

MOUNTING TEMPLATE

49-80514 10/07 JR

Printed in Mexico

15-7/16″

10-1/16″

1-1/4″

9-7/16″

TOP

MOUNTING

HOLE

DRILL 1/8″

PILOT HOLE

TOP

MOUNTING

HOLE

DRILL 1/8″

PILOT HOLE

BOTTOM

MOUNTING

HOLE

BOTTOM

MOUNTING

HOLE

NOTE:Top

mounting

screws MUST

engage wood

support.

NOTE: Top

mounting

screws MUST

engage wood

support.

Installation Height

Align Bottom Edge With

Pencil Line Indicating

Bottom of Hood

INSTALLATION—VENTED TO THE OUTSIDE

Centerline cutout

MOUNT THE HOOD

WARNING:2 people are required to lift and position

the hood onto the mounting screws.

• Lift the hood onto the mounting screws.

• Check level and mark bottom screw locations.

• Remove the hood.

• Drill 1/8″pilot holes in the marked location.

• If pilot holes do not enter studs, enlarge the holes to 3/8″

and install metal wall fastener anchors (provided).

• Lift the hood onto the mounting screws.

• Install lower screws to pull the hood tight against the wall.

• Tighten the top mounting screws.

Tighten

screws

Install

screws

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

GE ZV830 Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Hottes de cuisine GE ZV830