GE ZV830 Manuel d'utilisateur télécharger pdf (Page 4)

Installation Preparation

ADVANCE PLANNING

• Determine the exact location of the vent hood.

• Plan the route for venting exhaust to the outdoors.

• Use the shortest and straightest duct route possible. For

satisfactory performance, duct run should not exceed 100 ft.

equivalent length for any duct configurations.

• Refer to “Duct Fittings” chart on page 5 to compute the

maximum permissible length for duct runs to the outdoors.

CAUTION:To reduce risk of fire and to properly

exhaust air, be sure to duct air outside—do not vent exhaust

air into spaces within walls or ceilings or into attics, crawl

spaces or garages.

WARNING: TO REDUCE THE RISK OF FIRE,

USE ONLY METAL DUCTWORK.

• Install a wall cap with damper or roof cap at the exterior

opening. Order the wall or roof cap and any transition

needed in advance.

Wall Framing for Adequate Support

• This vent hood is heavy. Adequate structural support must

be provided in all types of installations. The hood must be

secured to vertical studs in the wall, or to a horizontal

support.

• The vent hood should be on site before final framing and

wall finishing. This will help to accurately locate the duct

work and electrical service.

• Installation will be easier if the vent hood is installed before

the cooktop and countertop are installed.

ACCESSORY DUCT COVER

This hood is shipped with a decorative duct cover for ceiling

heights of 7′11″to 10′. The ZX83012 duct cover accessory

is available to reach ceiling heights between 10′1″and 12′.

The accessory should be ordered with the hood and be

on site before installation begins.

POWER SUPPLY

IMPORTANT – (Please read carefully)

WARNING: FOR PERSONAL SAFETY,

THIS APPLIANCE MUST BE PROPERLY GROUNDED.

Remove house fuse or open circuit breaker before beginning

installation.

Do not use an extension cord or adapter plug with this

appliance. Follow National electrical codes or prevailing local

codes and ordinances.

Electrical supply

These vent hoods must be supplied with 120V, 60Hz, and

connected to an individual, properly grounded branch circuit,

and protected by a 15 or 20 amp circuit breaker or time

delay fuse.

• Wiring must be 2 wire with ground.

• If the electrical supply does not meet the above

requirements, call a licensed electrician before proceeding.

• Route house wiring as close to the installation location as

possible, in the ceiling or back wall. Refer to Wiring Locations

on page 9.

• Connect the hood wiring to the house wiring in accordance

with local codes.

Grounding instructions

The grounding conductor must be connected to a grounded

metal, permanent wiring system, or an equipment-grounding

terminal or lead on the hood.

WARNING:The improper connection of the

equipment-grounding conductor can result in a risk of

electric shock. Check with a qualified electrician or service

representative if you are in doubt whether the appliance is

properly grounded.

CAUTION:Automatically Operated Device –

To reduce the risk of injury disconnect from power supply

before servicing. This unit is equipped with an integral

disconnecting switch located inside the blower housing.

1 2 3 4 5 6 7 8 9 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

GE ZV830 Manuel d'utilisateur Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Hottes de cuisine GE ZV830