GE JBP22GR Manuel d'utilisateur Page 23

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 32
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 22
Drip Pans
Surface
Unit
‘Drip
Pan
To
remove
the drip pans for cleaning. the surface units
must
be
removed first. Lift the surface unit about one
inch
above
the
drip pan and pull it out. Make sure the
surface units
are
completely cool
bejbre
touching
them.
Clean
the drip pans with soap and water, plastic
scouring
pad
or in the dishwasher. DO NOT CLEAN
IN SELF-CLEANING OVEN; pans will discolor.
Wipe
after
each
cooking
so
unnoticed spatter
will
not
burn
on
the
next time you cook.
Do not lift the surface unit more than one inch. If
you do, it may not lie flat on the drip pan when you
plug it back in.
Repeated lifting of the surface unit more than one
inch above the drip pan can permanently damage
the receptacle.
To replace a surface unit:
Replace the drip pan into the recess in the cooktop.
Make sure opening in the pan lines up with
the receptacle.
Insert the terminals of the surface unit through the
opening in the drip pan and into the receptacle.
Guide the surface unit into place so it rests evenly.
Do not cover the drip pans with aluminum foil. Using
aluminum foil so close to the receptacle could cause
shock, fire or damage to the range.
Cooktop Surface Lamp
(on some models)
When changing a cooktop lamp, do not touch the
To replace:
metal at the ends of the lamp.
Place fingers on the top
‘l’he
cook(op
li~ht
is easily replaced with a fluorescent
each end of the lamp.
near
tube
of
the ~an;e
wattage._
Be~”ore
changing the lamp,
Press the lamp into the slots
pLl\]
the
p]LIg
to
the
range
or disconnect the power at the
until it snaps into place.
main
fuse or circuit breaker panel.
Move lamp cover down and
To
remove:
snap into place.
Lift the
lamp
cover by pulling the bottom edge toward
you
tind
then up.
Place
fingers
on
top near each end of the lamp.
RtJll
the top
of
the lamp gently toward the front of the
range and ~ently pull the-lamp from the socket,
making
sure it does not hit the lamp cover.
Oven Vent
The oven is
~ented
through
an
opening under the right
rear surface unit. Never cover the opening with
aluminum foil or any other material. This would
prevent the oven vent from working properly.
Vent
(continued next
page)
23
Vue de la page 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Commentaires sur ces manuels

Pas de commentaire