GE JBP22GR Manuel d'utilisateur télécharger pdf (Page 27)

PREWRE

THE OPENING (continued)

Flooring Under the Range

Your range, like many other household

items, is heavy and can settle into soft

floor coverings such as cushioned vinyl or

carpeting.

When moving the range on this type

of flooring, use care, and follow these simple and

inexpensive instructions.

The range should be installed on a 1/4 inch thick

sheet of plywood (or similar material) as follows:

When the floor covering ends at the

fhont

of the

range, the area that the range will rest on should

be built up with plywood to the same level or

higher than the floor covering. This will allow

the range to be moved for cleaning or servicing.

STEP 2

PREIMRE

FOR ELECTRICAL CONNECTION

Use only a 3-conductor, or if required a

conductor range cord set as noted below. These

cord sets are provided with ring type terminals.

The electrical rating of the cord must be 125/250

volts minimum, 40 amperes.

NOTE: Only a 4-conductor cord is to be used

when the appliance is installed in a mobile home

or where local codes do not permit grounding

through the neutral.

STEP 3

1. Locate connector block at the bottom rear of

range and remove rear wiring cover.

2. Directly below the connector block is a hole

with a knockout ring for accommodating conduit

fittings. Brackets provided are used to support

the flexible cord strain relief, which must be

securely attached to the cord set.

TOR

STRAIN RELIEF

(PROVIDED WIT

SET NOT PART

STEP 4

3+UIRE SYSTEM

Power Cord Installation-Insert screws

through power cord terminals so that the screws

pass through connector block terminals and

engage nuts. Tighten screws securely.

SCREW+

POWER CORD

RING TERMINAL

::~:R

CONNECTOR

BLOCK

~4:ABLE

TERMINAL

Cable Direct Installation-Clamp bare wires

between the connector block terminals and

movable nuts with

screws tightened securely.

1. Copper Wiring

Connect the neutral or grounded wire of the

supply circuit to the neutral terminal of the

connector block, located in the center. The

power leads must be connected to the outside

(brass colored) terminals.

NEUTRAL

TERMINAL

NG STRAP

ING TO RANGE)

WARNING: CONNECTOR BLOCK IS

APPROVED FOR COPPER WIRE

CONNECI’ION ONLY.

(continued next page)

—

—————.

—

1 2 ... 22 23 24 25 26 27 28 29 30 31 32

Commentaires sur ces manuels

Pas de commentaire

GE JBP22GR Manuel d'utilisateur Page 27

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers GE JBP22GR