GE JBP55 Manuel d'utilisateur Page 27

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 36
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 26
-----
—~””
Control Panel and Knobs
Clean up any spills or spatters with a damp cloth.
Remove heavier soil with warm, soapy water.
Clean the control panel with mild liquid dish
detergent and
a
soft cloth. Rub control
panel
lightly.
CAUTION: Do not use abrasives of any kind on the
control
panel.
The lettering on models with touch
pads is sensitive to abrasives and pressure.
The control knobs may be removed
for
easier
cleaning. To remove a knob, pull it straight off
the stem. Wash the knobs in soap and water but
do not soak.
Cooktop
Surface Light
(on some models)
When changing a
cooktop
light, do not touch the
To replace:
metal at the ends of the light.
Place fingers on the top near each end of the
light.
The
cooktop
light is easily replaced with a fluorescent
Press the light into the slots until it snaps into place.
tube of the same wattage. Before changing the light,
Move light cover down and snap into place.
pull the plug to the range or disconnect the power at
the main fuse or circuit breaker panel.
To
remove:
Lift the light cover by pulling the bottom edge
toward you and then up.
Place fingers on top near each end of the light.
Roll the top of the light gently toward the front of
the range and gently pull the light from the socket,
making sure it does not hit the light cover.
Metal Parts
Glass Window
Painted Surfaces
Do not use steel wool, abrasives,
To clean the outside of the oven
Painted surfaces include the
ammonia or commercial oven
window use
a
glass cleaner. Rinse
outside oven door, sides, control
cleaners. To safely clean surfaces;
and polish with a dry cloth.
panel and drawer front. Clean
wash, rinse and then dry with a
these with soap and water or a
soft
cloth.
vinegar and water solution. Do not
use commercial oven cleaners,
cleansing powders, steel wool or
harsh abrasives on any painted
surface.
Oven Vent
The oven is vented through an opening under the right rear surface unit.
Never cover the opening with aluminum foil
or
any
other material. This
would prevent the oven vent from working properly.
((c)ntinu<’d next
pa~<,)
a
c
Oven Vent
a
1’
27
Vue de la page 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Commentaires sur ces manuels

Pas de commentaire