GE JBP55 Manuel d'utilisateur télécharger pdf (Page 28)

CAm

AND

CLEAN~G

(continued)

Lift-Off Oven Door

The oven door is removable,

but it is heavy. You may need

help removing and replacing the

door. Do

not

lift the door by the

handle. This

can

cause the glass

break or

can

cause damage to

the door.

remove the door,

open it a

few inches to the special stop

position that will hold the door

open. Grasp firmly on each side

and lift the door straight up and

off the hinges.

NOTE: Be careful not to place hands between the

hinge and the oven door frame as the hinge could

snap back and pinch fingers.

To replace the door,

make sure the hinges are in the

special stop position. Position the slots in the bottom

of the door squarely over the hinges. Then lower the

door slowly and evenly over both hinges at the same

time. If the hinges snap back against the oven frame,

pull them back out.

TO CLEAN THE DOOR:

Inside of the door:

● Because the area inside the gasket is cleaned during

the

self clean cycle, you do not need to clean this

by hand. Any soap left on the liner causes additional

stains when the oven is heated.

“

The area outside the gasket can be cleaned with

a scouring pad.

● Do not rub or clean the door gasket—

the fiberglass material

of the gasket has an

extremely low resistance to abrasion. An intact and

well-fitting oven door gasket is essential for

energy-

efficient oven operation

and

good baking results.

If you notice the gasket becoming worn, frayed or

damaged in any way or if it has become displaced

on the door, you should have it replaced.

NOTE: The gasket is designed with a gap at the

bottom to

allow

for proper air circulation.

Inside Gasket

Gasket

Outside Gasket

Outside of the door:

● Use soap and water to thoroughly clean

the

top,

sides and front of the oven door. Rinse well. You

may also use a glass cleaner to clean the

glass

the outside of the door.

● Spillage of marinades, fruit juices, tomato sauces

and basting materials containing acids may cause

discoloration and should be wiped up immediately.

When the surface is cool, clean and rinse.

● Do not use oven cleaners, cleansing powders or

harsh abrasives on the outside of the door.

Oven Light Replacement

CAUTION: Before replacing your oven light bulb,

disconnect the

electri; power for your range at the

main fuse or circuit breaker panel or pull the plug.

Be sure to

let

the light cover and bulb cool completely

before removing or replacing them. When in use, light

bulbs can become warm enough to break

if touched

with a moist cloth or towel. When cleaning, avoid

touching warm lights with cleaning cloths if the light

cover is removed.

The oven light (bulb) is

covered with a removable

glass cover

which is held

in place with a wire. Remove

the oven door, if desired, to

reach the cover easily.

\J.,)”

1’

Wire cover holder

To remove:

● Hold your hand under the cover so it doesn’t fall

when released. With fingers of the same hand,

firmly push back the wire cover holder. Lift off

the cover.

DO NOT REMOVE ANY SCREWS.

● Replace bulb with 40-watt home appliance bulb.

To replace cover:

● Place it into the groove of the

light

receptacle. Pull

the wire forward to the center of cover until it snaps

in place. When in place, the wire holds the cover

firmly. Be certain the wire is in the depression in the

center of the cover.

● Connect electric power to the range.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Commentaires sur ces manuels

Pas de commentaire

GE JBP55 Manuel d'utilisateur Page 28

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers GE JBP55