GE JG5P38 Manuel d'utilisateur télécharger pdf (Page 45)

E

CONVERTING SURFACE BURNERS

ON

MODELS EQUIPPED

WITH

SEALED BURNERS

(See

Step 4 if range is equipped with standard

twin burners.)

1. Remove grates, burner caps and burner heads.

2. Using a

torxdriver,

remove the burner bases

by unscrewing the 3 small screws in each base.

Lift

the burner straight out.

DO NOT disconnect the wires from the burner

bases unless the

cooktop

needs to be raised.

3. Remove the brass orifice spud under each

burner base by unscrewing spud from fitting with

a 7 mm or a small adjustable wrench (depending

on the size of your spuds). Apply a 3/4” wrench

to the hex on

the gas inlet tube as a back-up

when removing spud to prevent the

aluminum from

tisting.

4. Install

or~lce

spuds according to one of the

following diagrams

(sqe

❑

or

~),

for

LP

gas

or natural gas, depending on which you are

converting to.

❑

orifice

Spuds

forconvetiingto

LpG~s:

LP

otilce

spuds are in a small plastic bag packed

with this Use and Care Guide.

LP

otilce

spuds

have a 2-digit number and the letter “L” on one

side. Each orifice spud will also have 1 or 2

grooves on one side, denoting the location on the

range where it is to be installed as shown below.

❑

OrifiCeSpudsfor

ConVetiingto

Natu~al

Gas:

Natural gas orifice spuds have a 3-digit number

on one side. Each

orfice

spud will also have 1, 2

or 3 grooves on one side, with the letter “N”

underneath denoting the location on the range

where it is to be installed as shown below.

(continued next page)

45

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 53 54

Commentaires sur ces manuels

Pas de commentaire