GE JSP34 Manuel d'utilisateur télécharger pdf (Page 13)

Features of Your Oven Control Oven Control, Clock and Timer

OVEN CONTROL, CLOCK AND TIMER

Clock To Set the Clock

The clock must be set for the automatic oven

timing functions to work properly. The time of day

cannot be changed during a Timed Baking or Self-

Cleaning cycle.

1. Press the CLOCK pad.

2. Press the INCREASE or DECREASE

pad to set the time of day.

CLOCK

Timer To Set the Timer

The timer is a minute timer;

it does not control oven operations.

The maximum setting on the timer

is 9 hours and 55 minutes.

1. Press the TIMER

ON/OFF pad.

2. Press the INCREASE

or DECREASE pad

to set the amount of

time on the timer.

The timer will start automatically

within a few seconds of releasing the

INCREASE or DECREASE pad. The

timer, as you are setting it, will display

seconds until one minute is reached.

Then it will display minutes and

seconds until 60 minutes is reached.

After 60 minutes, it will display hours

(“HR” now appears in display) and

minutes until the maximum time of

9 hours and 55 minutes is reached.

TIMER

ON/OFF

To Reset the Timer To Cancel the Timer

If “TIMER” is displayed, press the INCREASE or

DECREASE pad until desired time is reached.

If “TIMER” is not displayed, press the TIMER

ON/OFF pad first, then follow the instructions above

to set the timer.

Press and hold the TIMER ON/OFF pad until the

word “TIMER” disappears from the display.

End of Cycle Tone Display Messages

The end of cycle tone is a series of three beeps

followed by one beep every six seconds. If you would

like to remove the signal that beeps every six seconds,

press and hold the CLEAR/OFF pad for 10 seconds.

To return the signal that beeps every six seconds,

press and hold the CLEAR/OFF pad for 10 seconds.

• If “clean” appears in the display, DOOR flashes

and the oven control signals, you set the self-clean

cycle and did not shut the door.

• If “LOCK” only appears in the display, the

oven door is in the locked position. BAKE, BROIL

and COOK TIME cannot be set if the door is in the

locked position.

Power Outage

After a power outage, when power is restored, the

display will flash and time shown will no longer be

correct—for example, after a 5-minute power

interruption the clock will be 5 minutes slow.

The display flashes until the clock is reset. All other

functions that were in operation when the power went

out will have to be programmed again.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

GE JSP34 Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers GE JSP34