GE JCS57 Manuel d'utilisateur télécharger pdf (Page 22)

OPEM~G T~ SELF-CLEAMG OWN

(continued)

Aftera CleanCycle

1.When the Oven Cleaning Light is off, turn the

NOTE: If you wish to start and stop clean at a later

OVEN TEMP knob to OFF.

timethanshownon theclock,pushin andturntheSTART

2. Turn the OVEN SET knob to OFF.The door

dialto the time you wish to start.Add the hours needed

will automatically unlatch and all signal lights

for the cleaning to this start time, then push in and turn

will be off.

the STOP (CLEAN) dial to the desired time. The oven

will automatically turn on and off at the set times.

ToStopa CleanCycle

CAUTION: After setting the oven for a clean cycle,

do not try to open the oven door as this can damage

the automatic door-locking system.

U you want to use the oven any time before a clean

cycle is done, turn the OVEN SET and the OVEN

TEMP knobs to OFF. After the oven cools, the

door will udock and can then be opened.

CAUTION: Should the oven door become locked

accidentally,

to open the door, turn the OVEN SET

knob back to CLEAN, push in and advance the STOP

dial past the time of day. Wait one minute then turn

the OVEN SET knob to OFF. Wait a few seconds and

the door may be opened.

H the door latch finger becomes positioned so as

to keep the oven door from closing all the way, this

can be corrected as follows:

● Make suretheoven is cool.

● Open the oven door, turnthe OVEN SET knob to

CLEAN. Push in and advance the STOP dial past

the time of day. Push in the oven interlock button

(button is at the right top of the oven door opening)

and hold the button in for about 15 seconds.

● Next, turn the OVEN SET knob to OFF and again

pushin theoven interlockbuttonfor about 15 seconds.

The latch finger, being motor driven, will turn so the

oven door may be closed.

QuestionsandAnswers

Q. ~ my oven clock is not set to the correct time

of day, can I still seE-clean my oven?

A. If the clock is not set to the correct time of day you

will not be able to set a delay clean to end at a

specific time.

Q. Is the “cracUing” or ‘~opping” sound I hear

during cleaning normal?

A. Yes.This

isthesoundofthemeti heatingandcookg

during both the cooking and cleaning functions.

Q. My oven shelves do not sfide easily.

What is the matter?

A. After cleaning, oven shelves will become so clean

they do not slide easily.To make the shelves slide

more easily, after each self-cleaning, dampen

fingers with a small amount of cooking oil and rub

lightly over the sides of the shelves where they

contact the shelf supports.

Q. What causes the hair-tike Hn= on the enameled

surface of my oven?

A. This is a normal condition, resulting from heating

and cooling during cleaning. These lines do not

affect how your oven performs.

Q. Should there be any odor during the cleaning?

A. Yes,there will be an odor during the first few

cleanings. Failure to wipe out excessive soil might

also cause a strong odor when cleaning.

Q. Why do I have ash left in my oven after cleaning?

A. Some types of soil will leave a deposit which is

ash.It can be removed with a damp spongeor cloth.

Q. What should I do if excessive smoking occurs

during cleaning?

A. This is caused by excessive soil. Turn the oven off.

Open the windows to rid the room of smoke. Wait

until the oven has cooled and the word “LOCK’ is

off in the display. Wipe up the excess soil and reset

the clean cycle.

Q. Can I use commercial oven cleaners on any part

of my seti-cleaning oven?

A. No cleaners or coatings should be used around any

part of this oven. If you do use them and do not

thoroughly rinse the oven with water, wiping it

absolutely clean afterwards, the residue can scar

the oven surface and damage metal parts the next

time the oven is automatically cleaned.

Q. My oven shelves have become gray after the

seti-clean cycle. Is this normal?

A. Yes.After the self-clean cycle, the shelves will

lose some luster and change to a deep gray color.

Q. Why won’t my oven clean immediately even

though I have set all the time and clean knobs

correctly?

A. Check to be sure that your START dial is set to the

same time as the oven clock.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

GE JCS57 Manuel d'utilisateur Page 22

Commentaires sur ces manuels

Produits connexes et manuels pour Fours GE JCS57