GE JCS57 Manuel d'utilisateur Page 5

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 36
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 4
Be sure the drippansand thevent duct arenot
coveredand arein place.Theirabsenceduring
cookingcould damagerange partsand wiring.
Do not use ahuninum foil to tine the drip pans
or anywherein the ovenexcept as describedin
this guide. Misusecouldresultin a shock,fire
hazard or damageto the range.
Ody certain types of @ass,~as#ceramic,
earthenware or other glazed containers are
suitible for cooktop service; othersmay break
because of the suddenchangein temperature.
To minimize the possibfity of burns, ignitionof
flammablematerialsand spillage,thehandleofa
containershouldbe turnedtowardthe centerof the
range withoutextendingovernearbysurfaceunits.
Always turn the surface units off before
removing
cookware.
Toavoid the possibility of a burn or electric
shock, alwaysbe certain that the controlsfor
all surfaceunitsare atthe offpositionand dl
coils are coolbefore attemptingto lift or remove
a unit.
Do not immerse or soak the removable surface
units. Do not put them in a dishwasher. Do not
seH-clean the surface uniti in the oven.
men flamingfoods areunder the hood,
turnthe fan off.The fan, if operating,may spread
theflame.
Keepaneye onfoods beingfried at high or
mediumhigh heat settings.
Foodsfor frying should be as dry as possible.
Frost on frozen foods or moistureon fresh foods
cancausehot fat tobubbleup and over the sides
of the pan.
Use Uttiefat for effectiveshallowor deep-fat
frying.Filling thepan too full of fatcan cause
spilloverswhen food is added.
E a combinationof otisor fa~ will be used
infrying,stir togetherbefore heating,or as fats
melt slowly.
Alwaysheat fat slowly,and watch as it heats.
Use a deepfat thermometerwhenever
possibleto preventoverheatingfat beyond
the smokingpoint.
Instilkg theRange
Your range, like many other household items, is
Men thefloor covering ends at thefront of the
heavy and can settle into soft floor coverings such
range, the area that the range will rest on should be
as cushioned vinyl or carpeting. Be careful when
built up with plywood to the same level or higher than
moving the range on this type of flooring. It should be
the floor covering. This will allow the range to be
installed on a 1/4”thick sheet of plywood (or similar
moved for cleaning or servicing.
material) as follows:
Leveltig the Range
~veling screws maybe located on each comer of
To remove the drawer, pull tie drawer out all the way,
the base. By removing the bottom drawer you can
tilt up the front and remove it. To replace, insert the
level the range to an uneven floor by adjusting the
glides at the back of the tiawer beyond the stop on
leveling legs.
the range glides. Lift the drawer if necessary to insert
it easily.Let the front of the drawer down, then push
it in to close.
5
Vue de la page 4
1 2 3 4 5 6 7 8 9 10 ... 35 36

Commentaires sur ces manuels

Pas de commentaire