GE JCS57 Manuel d'utilisateur télécharger pdf (Page 29)

STEP1

WARN~G: E~~C~ GROUND IS

REQU~D ON ~IS APP~CE.

~is apphance is manufactured with the neuti

terminal connected to the frame.

1. H lod codes permit comection of tie

be grounding conductor to the neuti

wire of the copper power supp~ cord:

A Removethe screws md rtise the terminal

blockcover ~owerpart ofthe back wire cover).

B. me

terminal nuts are taped to the frame

below the terminal block.

N~: Do notloosen factory instiled nuts.

C. Connectthe neuti wire ofthe copper

power supplycord to the center sflvercolored

terminal ofthe terminal blockand connectthe

outer wiresto the outer terminals.SeeFigure 1.

Ringtype terminals must be used on copper

power supplycord wires.

D. Replacethe terminal block cover.

2. If connecting to a four-wire electrical system

(mobile home):

IPOWER SUPPLY!

FIGURE 2

A. Removethe screws and raise the

terminal block cover.

B. Removethe ground strap from tie

terminal block and horn the apphance

frame. Retainthe ground screw.

C. Connectthe ground wire been) ofthe

copper power supplycord to the frame of

the appfiancewith the ground screw,using

the hole in the frame where the ground

strap was removed. See Figure 2.

D. Connect the neutral (white) wire of the

copper power supply cord to the center

silver colored terminal of the terrnind

block and connect the other wires to the

outer terrninds.

E. Replacethe terminal block cover.

(continuedflint page)

29

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36

Commentaires sur ces manuels

Pas de commentaire