Ge 164D3333P185-1 Manuel d'utilisateur télécharger pdf (Page 8)

Customer Service Troubleshooting Tips Installation Instructions Care and Cleaning Operating Instructions Safety Instructions

Using the surface burners.

Throughout this manual, features and appearance may vary from your model.

Lighting Instructions for Electric Ignition Models

The surface burners on some models are lighted

by electric ignition, eliminating the need for

standing pilot lights with constantly burning

flames.

In case of a power failure,

you can light

the surface burners on your range with a

match. Hold a lighted match to the

burner, then turn the knob to the

LITE

position.

Use extreme caution when

lighting burners this way.

Surface burners in use when an

electrical power failure occurs will

continue to operate normally.

The electrode of the spark igniter is

exposed. When one burner is turned

LITE,

all the burners spark. Do not

attempt to disassemble or clean

around any burner while another

burner is on.An electric shock may

result, which could cause you to

knock over hot cookware.

Lighting Instructions for Standing Pilot Models

The surface burners on these ranges have

standing pilots that must be lit initially.

To light them:

Be sure surface burner control knobs

are in the

OFF

position.

Lift the cooktop up or off (see the

Care and cleaning of the range

section).

Locate the 2 pilot ports and light

each of them with a match.

If the pilots need adjusting, turn the

adjusting screw located on the pilot

filter.

Lower the cooktop. Your surface

burners are now ready for use.

Observe lighted burners. Compare

the flames to pictures in the

Before

you call for service

section. If any

flame is unsatisfactory, call for

service.

Surface Burner Controls

The knobs that turn the surface burners on and

off are located on the control panel on the front

of the range. The two knobs on the left control

the left front and left rear burners. The two knobs

on the right control the right front and right rear

burners.

To Light a Surface Burner

Push the control knob in and turn it

LITE

(

on pilot models). On

electric ignition models, you will

hear a little

clicking

noise—the

sound of the electric spark igniting

the burner.

After the burner ignites, turn the

knob to adjust the flame size.

After Lighting a Burner

■ Check to be sure the burner you turned

on is the one you want to use.

■ Do not operate a burner for an

extended period of time without

cookware on the grate. The finish on

the grate may chip without cookware

to absorb the heat.

■ Be sure the burners and grates are

cool before you place your hand, a

pot holder, cleaning cloths or other

materials on them.

Manifold pipe

Top pilots

adjustment screw

Top pilots adjustment screw controls

the rate of gas to the top burner

pilots.

Thermostat

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Ge 164D3333P185-1 Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Radio Ge 164D3333P185-1