GE JGBP38 Manuel d'utilisateur télécharger pdf (Page 48)

CONVERTING TO LP GAS (Standard Twin Burner models only)

or Converting Back to Natural Gas from LP

CONVERT THE OVEN BURNER ORIFICES

Oven Burner

1. Remove oven door, storage drawer and oven

bottom. The lower burner orifice spud is located

behind the storage drawer or kick panel. (On some

models, a metal shield must be removed to access

the orifice.)

2. To convert to LP gas,

use a 1/2″ wrench to

turn the lower burner

orifice spud clockwise.

Tighten the spud only

until it is snug. To

prevent damage, do not

overtighten the spud.

To convert to natural gas, loosen the spud

about 2 turns.

Broil Burner

To convert to LP gas, use a 1/2″ wrench to turn

the upper burner orifice spud clockwise. Tighten

spud only until it is snug with the base. To prevent

damage, do not overtighten spud.

To convert to natural gas, loosen the spud

about 2 turns.

CONVERT AIR ADJUSTMENT SHUTTER

For LP gas, loosen the Phillips

head screw and rotate the

shutter to the full open position.

With baffle in place, flames

should have approximately 1-

inch blue cones and should not

extend beyond the edges of the

burner baffle. After 30 seconds of burner

operation, check for flames lifting off burner

ports. If lifting is observed, gradually reduce air

shutter opening until flames are stabilized.

For natural gas, the shutter should be open

1/2″ or about 3/4 of the way open.

Screw

Air

Shutter

CONVERTING SURFACE BURNERS

1. Lift cooktop.

2. Lift burner assemblies straight up and set

aside to gain access to surface burner spuds.

3. With a 7mm, 5/16″ or small adjustable

wrench, remove each of the four spuds on the

surface burner gas inlet tubes and replace them

with the correct gas spuds mounted in a holder

at the right rear of the range, above the

regulator. Natural gas spuds are brass and LP

gas spuds are red or silver. (Mount the spuds

that you removed from the inlet tubes back in the

holder.) To prevent leakage, make sure spuds are

securely screwed into gas inlet tubes.

4. Replace the burner assemblies.

5. Keep all spuds with your range so you have

them if you move or get a different gas hook-up.

Top Burner Orifice Drill Size Color

Natural Gas #54 (.0550 Dia.) Brass

LP (Propane) #66 (.0330 Dia.) Red or Silver

Natural gas

= brass

LP gas =

red or silver

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 54 55 56

Commentaires sur ces manuels

Pas de commentaire

GE JGBP38 Manuel d'utilisateur Page 48

Commentaires sur ces manuels

Produits connexes et manuels pour Poêles GE JGBP38