Ge PGP989SNSS Manuel d'utilisateur télécharger pdf (Page 24)

INSTALLING THE FOAM GASKET AND

REFLECTIVE TAPE

CAUTION: Potential risk of fire –

reflective tape must be secured around

countertop opening as shown.

Do not install the cooktop into the countertop

without installing the foam gasket as shown.

It protects the bottom edge of the glass from the

countertop and seals the cooktop against spills.

Remove the cooktop along with its shipping pad

from the shipping box. Remove the shipping block

from the downdraft vent opening and place it under

the shipping pad to provide level support.

CAUTION: GLASS IS FRAGILE.

DO NOT BUMP EDGE OF GLASS DURING

INSTALLATION.

Locate the reflective tape and foam gasket tape

included with your cooktop.

Smooth rough edges of the cutout. Install reflective

tape to the opening, along the inside and 3/8" to

1/2" of the opening edge.

Peel off the white backing to install the foam gasket

tape on the bottom side of the cooktop glass as shown.

Underside

of Glass

Foam

Gasket

Tape

⁄8

”

max. to

Glass Edge

Foam Gasket Installation Notes:

• The foam gasket tape should be installed within

1/8" of the edge of the glass. Do not stretch or

twist the foam gasket tape.

CAUTION: Failure to install foam

gasket tape greatly increases the potential

of breaking the cooktop glass when installing,

especially in Corian

or granite countertops.

•

Use care not to stretch the foam gasket tape

while it is installed or it will not stay in place.

•

Do not place foam gasket tape over the metal

flanges.

•

Butt the foam gasket tape ends together at each

corner without overlapping.

•

Trim the foam gasket tape to length without

stretching.

•

Mitre cut outside corners of foam gasket tape

slightly if necessary for appearance.

• Do not scratch the glass while cutting the foam

gasket tape.

Installation Instructions

UNPACKING THE COOKTOP/INSTALLING THE GASKET

Place reflective tape within

1/2" of cutout

Reflective tapetop

and vertical sides

Center vent shipping block –

place under the shipping pad to

provide level support

Note: On PGP989S model, apply the foam tape

around the outer edge of the glass only on the sides

and rear of the unit.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 71 72

Commentaires sur ces manuels

Pas de commentaire

Ge PGP989SNSS Manuel d'utilisateur Page 24

Commentaires sur ces manuels

Produits connexes et manuels pour Poêles Ge PGP989SNSS