Ge PGP989SNSS Manuel d'utilisateur télécharger pdf (Page 26)

INSTALLING THE BLOWER

TO THE PLENUM

Orient the blower discharge opening to match the

ductwork in Steps 5 and 6. Slide the four threaded

studs on the side of the blower housing into the

four holes on the side of the plenum.

NOTE: See Step 13 for installing the transition

duct to the blower. It may be easier to install the

transition duct to the blower before installing the

blower to the plenum.

From the vent opening in the top of the cooktop,

fasten the blower assembly securely to the plenum

with four (4) nuts.

INSTALLING THE BLOWER PLENUM

TO THE COOKTOP

Slide the plenum, with the blower opening on the

left, into the opening in the bottom of the cooktop.

Push up on the plenum until the stops on the

plenum contact the bottom of the cooktop, and

snap the plenum into place. (You may have to move

the plenum back and forth to work it into place.)

Secure the plenum to the bottom of the cooktop,

on each side, using the four (4) screws provided.

Further secure the plenum to the cooktop, from

the top side, using the two screws (2) provided.

Installation Instructions

INSTALLING THE COOKTOP

4 Nuts

(7/16"

socket

required)

Install 4 screws

Install 2 screws

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 71 72

Pas de commentaire

Ge PGP989SNSS Manuel d'utilisateur Page 26