GE 27957 Manuel d'utilisateur télécharger pdf (Page 39)

Erase message 0 (during message playback)

Skip message 3

Turn off/on answering system 4

Review voice menu options 7

The base LCD shows REMOTE ACCESS ANSWERING CALL.

TIP: You can bypass the outgoing announcement by pressing any numbered

key on the touch-tone pad while the announcement is playing. Then, you can

enter your security code to access the answering system.

Changing the Security Code

The default security code for accessing the answering system from another

location is 1 2 3.

The security code is set through the programming menu. Refer to Telephone

Set Up for more information.

Changing the Battery

Make sure the telephone is OFF (not in TALK mode) before you replace

battery.

1. Remove the battery compartment cover.

2. Disconnect the battery plug from the jack inside the battery compartment

and remove the battery pack from the handset.

3. Insert the new battery pack and reconnect the battery plug to the jack

inside the compartment.

4. Put the battery compartment cover back on.

5. Place handset in charge cradle to charge. If you don’t charge the

handset battery properly (for 16 hours) when you ﬁrst set up the phone

and/or when you install a new battery pack, the battery’s long-term

performance will be compromised.

NOTE: If the battery is not properly installed in the handset, or if the battery

pack is not properly connected to the jack inside the battery compartment,

“NO BATTERY” shows in the display when you place the handset back in the

charge cradle.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 99 100

Pas de commentaire

GE 27957 Manuel d'utilisateur Page 39