Ge 206C1559P197 Manuel d'utilisateur télécharger pdf (Page 11)

• Connect drain line to air gap, waste tee or disposer

using the previously determined method. Secure hose

with a screw-type clamp.

Waste Tee Installation

Method 1 – Air gap with waste tee or disposer

Disposer Installation

Waste Tee Installation

Method 2 – “High drain loop” with waste tee or disposer

With this method you will need the drain hose hanger set aside

in Step 1.

Fasten drain hose to underside of countertop with the provided

hanger.

Disposer Installation

Figure Y

Figure Z

IMPORTANT – When connecting drain line to

disposer, check to be sure that drain plug has been removed.

DISHWASHER WILL NOT DRAIN IF PLUG IS LEFT IN PLACE.

Dishwasher Installation

STEP 17: CONNECT DRAIN LINE

The molded end of the drain hose will fit 5/8" through 1"

diameter inlet ports on the air gap, waste tee or disposer.

• Determine size of inlet port.

• Cut drain hose connector on the marked line, if required,

to ﬁ t the inlet port.

• If a longer drain hose is required and you did not purchase

drain hose GPF10L, add up to 42" length for a total of 120"

(10 feet) to the factory-installed hose. Use 5/8" or 7/8" inside

diameter hose and a coupler to connect

the two hose ends.

Secure the

connection

with hose

clamps.

Figure W

Figure X

NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10 FEET

FOR PROPER DRAIN OPERATION.

7^bT2[P\_

2^d_[Ta

7^bT2[P\_

Remove

Drain

Plug

Tip: Avoid unnecessary service call charges for a no drain

complaint.

Make sure excess drain hose has been pulled through

the cabinet opening. This will prevent excess hose in the

dishwasher cavity from becoming kinked or crushed by the

dishwasher.

STEP 16: CONNECT WATER SUPPLY

Connect water supply line to 90° elbow.

• Slide compression nut, then ferrule over end of water line.

• Insert water line into 90° elbow.

• Slide ferrule against elbow and secure with compression nut.

IMPORTANT – Check to be sure that door spring

and/or door spring cable do not rub or contact the ﬁ ll hose or

water supply line.

Test by opening and

closing the door.

Reroute the water

supply lines if a

rubbing noise or

interference

occurs.

Figure V

90° Elbow

Ferrule

90° Elbow

Door Spring

Hot Water

Supply Line

Compression

Nut

Cutting Line

5/8"

IMPORTANT: Do not cut corrugated

portion of hose

18"

Min.

32"

Min.

32"

Min.

18"

Min.

Drain Hose Hanger

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Ge 206C1559P197 Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle Ge 206C1559P197