GE General Electric Dishwasher GSD 5200 Manuel d'utilisateur télécharger pdf (Page 5)

Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions

Options

The light above the selected pad will be ON to indicate which OPTION has been selected.

HI TEMP

Turns on the heater in all postrinse and final rinse cycles to help prevent spotting on dishware. This option may be turned

RINSE ON

OFF

during the wash cycle.

HI TEMP

Energizes the heater to boost water temperature in all prewash and main wash fill cycles. Recommended for use with

WASH

heavily soiled dishes. Option may be turned

OFF

during the wash cycle.

HEATED DRY

Shuts off the drying heat option. Dishes air dry naturally and energy is saved. You can prop the door open after the

OFF CLEAN

light illuminates.

HEATED DRY

Turns the heater on for fast drying. This cycle will extend the time to your wash cycle by 30 minutes.

NOTE:

Cannot be

selected with

RINSE ONLY

cycle.

LOCK

When the

LOCK

pad is touched twice within 3 seconds, all pads become inoperative.

You can lock the controls to prevent any

selections from being made. Or you can lock the controls after you have

started a cycle or selected DELAY START so the cycle or

DELAY START is not interrupted.

Children cannot accidentally start dishwasher by touching pads with this option selected.

To unlock the dishwasher after it has been locked, touch the

LOCK

pad twice within 3 seconds. The light above the

LOCK

pad will

turn off.

DELAY START

You can delay the start of a wash cycle for up to 8 hours. Press the

DELAY START

pad to choose the number of hours you

want to delay

the start of the cycle. The machine will count down and start automatically

at the correct time.

Pressing the

START/RESET button will cancel the DELAY START selection. NOTE:

If you forget to latch the door, a reminder

signal will beep until you do so.

RESET

To change a cycle after washing starts, touch the

START/RESET

pad to cancel the cycle. After water is pumped out and

the motor stops, you can reprogram and restart the dishwasher. This will take approximately 90 seconds.

Cycle Selections

The light above the selected pad will be ON to indicate which CYCLE SELECTION has been selected

POTS & PANS For heavily soiled dishes or cookware with dried-on or baked-on soils.

Everyday dishes may be included.

This cycle will not remove burned-on foods.

NORMAL

For loads of everyday dishes, glasses and cookware with medium soils.

NOTE:

Many dishes have lighter soil than normal.

Choosing

a cycle other than

NORMAL

will save energy and water.

LIGHT WASH For dishes with light soils.

CHINA CRYSTAL For lightly soiled china and crystal.

RINSE ONLY For rinsing partial loads that will be washed later.

Do not use detergent.

Start

Close and latch the door. Touch the

START/RESET

pad to begin the cycle. Water fill begins and

approximately 40 seconds later the wash action begins.

NOTE:

The dishwasher remembers your last cycle so you don’t have to reprogram each time.

When the dishwasher is loaded and the door latch is in the locked position, the control panel

lights will be

and display the last settings you selected.

If you don’t want to change any of the settings, simply touch the

START/RESET

pad to begin the

cycle.

Also, if a power failure occurs,

NORMAL

and

HEATED DRY

will automatically be programmed.

Make any new selections and touch the

START/RESET

pad to begin the cycle.

Control Settings

GEAppliances.com

Clean

This light is illuminated when a wash cycle is complete. The light will stay

until the door is

opened.

1 2 3 4 5 6 7 8 9 10 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

GE General Electric Dishwasher GSD 5200 Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle GE General Electric Dishwasher GSD 5200