GE General Electric Dishwasher GSD 5200 Manuel d'utilisateur télécharger pdf (Page 6)

Flashing display lights.

Operating Instructions Safety InstructionsConsumer Support Troubleshooting Tips

Lights What It Means What To Do

This is normal. Allow the dishwasher to drain and reset before you start a new wash cycle.

The

START/RESET

pad

has been pressed.

Control Error Press the

START/RESET

pad to turn off the beeper. If the

CLEAN

light continues

to flash, call for service.

Control Error Press the

START/RESET

pad to turn off the beeper and the dishwasher will

attempt to reset. Then restart the wash cycle. If this error continues, call for

service.

NORMAL

PLUS A

BEEPING

SOUND

RESET

STARTSTART

CLEANCLEAN

PLUS A

BEEPING

SOUND

Filling the Dispenser

Fill the rinse agent dispenser until it reaches the bottom

of lip inside the opening. Replace cap.

To check if rinse agent is needed:

On some models, remove the cap and look into the

dispenser.

On some models, press the clear center of the fill cap

2 or 3 times. If rinse agent fills the center of the cap, you

have enough.

A full dispenser should last about one month.

If rinse agent spills, wipe up the excess.

Check the Water Temperature

The entering water must be at least 120°F and

not more than 150°F for effective cleaning and to

prevent dish damage. Check the water temperature

with a candy or meat thermometer. Turn on the

hot water faucet nearest the dishwasher, place

the thermometer in a glass and let the water run

continuously into the glass until the temperature

stops rising.

Use Jet-Dry

Rinse Agent

Jet-Dry

rinse agent removes spots and prevents new film buildup on your dishes, glasses,

flatware, cookware and plastic.

Using the dishwasher.

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

GE General Electric Dishwasher GSD 5200 Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle GE General Electric Dishwasher GSD 5200