GE GLDT696JSS Manuel et guide de l'utilisateur télécharger pdf (Page 5)

GEAppliances.com

Start Dishwasher

Start/Reset

Press the Start/Reset button and close the door within 4 seconds to start the cycle or begin the

Delay start countdown. The Start/Reset LED will light. The wash cycle will begin after 10 seconds

and then pump out for 60 seconds prior to filling the dishwasher with water. To activate the display,

press any button with the door open.

Interrupt or

Pause

To interrupt or pause a cycle, slowly open the door. Opening the door will cause the wash cycle to

pause. The dishwasher will beep every minute to remind you to close the door. To restart or resume

the cycle, press Start/Reset, and close the door within 4 seconds. If the door is not closed within 4

seconds, the Start/Reset LED will start blinking and the dishwasher will beep once every minute to

signal that the cycle did not restart. If the Start/Reset LED is blinking, the dishwasher is waiting for

input.

Cancel

To cancel a wash cycle, press and hold the Start/Reset button for 3 seconds with the door open,

and then close the door. The dishwasher will drain and the wash cycle lights will turn off.

Status Indicators

Sanitized

If the Sanitize cycle is selected, the sanitized indicator light will be turned on at the end of the cycle.

If the NSF requirements for sanitization are not reached, the light will not turn on.

Clean

The green light will display and a beep will sound to alert you that the wash cycle is complete. If the

door is NOT opened, the beep will sound 4 times

2 Digit Display

This display is used for Delay start and cycle time countdown.

When a cycle is selected, the display is populated with the total number of minutes in the cycle, until it reaches 99

minutes (Sanitize, Heavy and Normal cycles).

Delay Start Option

This option allows you to delay the start of a wash cycle for up to 24 hours.

With the door open and a cycle selected, press the Delay button to choose the number of hours you want to delay the

start of the wash cycle. The hours will show in the display window.

NOTE: You may press the Start/Reset button to cancel the Delay hours option before the start of the cycle.

1 2 3 4 5 6 7 8 9 10 ... 51 52

Pas de commentaire

GE GLDT696JSS Manuel et guide de l'utilisateur Page 5