GE GLDT696JSS Manuel et guide de l'utilisateur télécharger pdf (Page 6)

Using the dishwasher

Check the Water Temperature

The entering water should be at least 120°F (49°C) and not

more than 140°F (60°C) for effective cleaning and to prevent

dish damage. Check the water temperature with a candy or

meat thermometer.

Turn on the hot water faucet nearest the dishwasher,

place the thermometer in a glass and let the water run

continuously into the glass until the temperature stops rising.

Rinse agents, such as Cascade

Rinse Aid are designed for great drying action and to protect against

spots and film build-up on your dishes, glasses, flatware, cookware, and plastic.

Filling the Dispenser

The rinse agent dispenser holds 3.5 oz. (104 ml) of rinse agent. Under normal

conditions, this will last approximately one month - depending on setting.

Make sure the dishwasher door is fully open.

Turn the dispenser cap to the left and lift it out.

Add rinse agent until the indicator window looks full.

Clean up any spilled rinse agent with a damp cloth to prevent foam from forming

inside the dishwasher.

Replace the dispenser cap.

Rinse Aid Setting

The amount of rinse agent released into the final wash can be adjusted. The factory setting is at

the midpoint. If there are rings of calcium (hard water) spots on dishes, try a higher setting (a higher

number indicates a higher dosage). If you observe foam in the final rinse, try a lower setting.

To adjust the setting

Remove the dispenser cap; then turn the adjuster counterclockwise to increase the amount of rinse agent

or clockwise to reduce the amount of rinse agent dispensed.

Use a Rinse Agent

Indicator

Dispenser cap

Adjustable setting

1 2 3 4 5 6 7 8 9 10 11 ... 51 52

Pas de commentaire

GE GLDT696JSS Manuel et guide de l'utilisateur Page 6