Ge PSB9240SFSS Manuel d'utilisateur télécharger pdf (Page 8)

Installation Preparation

Preparation WITH an Accessory Storage Drawer

NOTE: MODEL ZSC2202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE INSTALLATION PREPARATION

WITHOUT AN ACCESSORY STORAGE DRAWER FOR THIS MODEL.

Installation over a GE/Monogram

Warming Drawer:

For existing cutouts, a maximum width of 28-1/2”

is acceptable. If the opening is slightly wider,

secure a furring strip on each side of the cutout

for securing the oven.

NOTE: Additional clearances between the cutouts

may be required. Check to be sure the oven

supports above the Warming Drawer location do not

obstruct the required interior depth and height. See

Warming Drawer installation instructions for details.

30”

23-1/2”

25-1/4”

Min.*

21”

36-3/4”

Min.

2” Min.

(3” recommended)

Per warming

drawer

requirement

Construct

Solid Bottom

Min. 3/8”

Plywood

Supported

by 2x4 or 2x2

Runners all

Four Sides

PREPARE THE OPENING

The Advantium 240V can be installed in

combination with other GE/Monogram appliances.

Always follow each product’s Installation

Instructions to complete the installation.

Single Advantium 240V Installation:

Order a 30” wide single oven cabinet or cut the

opening in a wall to the dimensions shown.

* For existing cutouts, a maximum width of 28-1/2”

is acceptable. If the opening is slightly wider,

secure a furring strip on each side of the cutout

for securing the oven.

$OZD\VPDLQWDLQµPLQLPXPKHLJKWIURP

the floor to the cutout in any single or combined

installation.

Allow 3/4” to 2-1/8” case trim overlap on the sides

and 7/8” overlap on the bottom of the opening

for all models. The amount of overlap on the sides

depends on the actual cutout width. Allow 1-1/4”

case trim overlap on the top for model PSB9120

and 3/4” overlap on the top for models ZSC2200,

ZSC2200, ZSC2201 and ZSC2202.

2YHQRYHUODSVZLOOFRQFHDOFXWHGJHVRQDOOVLGHV

of the opening.

30”

23-1/2”

25-1/4”

Min.*

21”

Construct

Base

Min. 3/8”

Plywood

Supported

by 2x4 or

2x2 Runners

all Four

Sides

36-3/4”

Min.

PREPARE THE OPENING (CONT.)

Single Advantium 240V Installation (cont.)

When installed over a single oven or a warming

drawer, allow at least 2” between the two openings.

This separation will provide clearance for bottom

overlap of the Advantium 240V and the other

appliance overlaps.

Construct a solid oven floor of 3/8” min. thick plywood

supported by 2 x 4 or 2 x 2 runners on all sides.

7KHVXSSRUWPXVWEHOHYHODQGULJLGO\PRXQWHG

flush with the bottom edge of the cutout.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Ge PSB9240SFSS Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Four Ge PSB9240SFSS