Ge PSB9240SFSS Manuel d'utilisateur télécharger pdf (Page 9)

Installation Preparation

Preparation WITH an Accessory Storage Drawer

NOTE: MODEL ZSC2202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE INSTALLATION PREPARATION

WITHOUT AN ACCESSORY STORAGE DRAWER FOR THIS MODEL.

PREPARE THE OPENING (CONT.)

Installation over a GE/Monogram Oven and

Warming Drawer:

* For existing cutouts, a maximum width of 28-1/2”

is acceptable. If the opening is slightly wider,

secure a furring strip on each side of the cutout

for securing the oven.

NOTE: Additional clearances between the cutouts

may be required. Check to be sure the oven supports

above the Warming Drawer location do not obstruct

the required interior depth and height. See Warming

Drawer installation instructions for details.

CAUTION: For personal safety, the

mounting surface must be capable of supporting

the cabinet load, in addition to the added weight

of this approximate 80-pound oven and 30-pound

drawer, plus additional oven loads of up to 50

pounds or a total weight of 160 pounds.

PRECAUCIÓN: Para seguridad

personal, la superficie de montaje debe poder

soportar la carga del gabinete, además del peso

aproximado de 80 libras del horno y las 30 libras

del cajón, más las cargas adicionales del horno

de hasta 50 libras o un peso total de hasta

160 libras.

Construct

Solid Bottom

Min. 3/8”

Plywood

Supported by

2x4 or 2x2

Runners all

Four Sides

30”

23-1/2”

21”

2” Min.

Per Oven

Requirement

45-1/4”

Min.

Per warming drawer requirement

2” Min.

(3” recommended)

PREPARE THE OPENING (CONT.)

Installation over a GE/Monogram Oven:

* For existing cutouts, a maximum width of 28-1/2”

is acceptable. If the opening is slightly wider,

secure a furring strip on each side of the cutout

for securing the oven.

,I\RXDUHUHSODFLQJD*(0RQRJUDPHOHFWULF

double oven with the combined installation of

an Advantium 240V and a single oven, use the

dimensions shown. The middle rail separating

the two openings may need to be larger than

the 2” minimum shown.

30”

23-1/2”

25-1/4”

Min.*

21”

2” Min.

(3” recommended)

45-1/4”

Min.

Construct Solid

Bottom Min.

3/8” Plywood

Supported by

2x4 or 2x2

Runners all

Four Sides

Per Oven

Requirement

25-1/4”

Min.*

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Ge PSB9240SFSS Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Four Ge PSB9240SFSS