GE JVM2052 Manuel d'utilisateur télécharger pdf (Page 12)

OUTSIDE TOP EXHAUST (Vertical Duct)

Installation Instructions

Place the mounting plate against the wall and insert

the toggle wings into the holes in the wall to mount

the plate.

NOTE: Before tightening toggle bolts and wood screw,

make sure the tabs on the mounting plate touch

the bottom of the cabinet when pushed flush against

the wall and that the plate is properly centered under

the cabinet.

CAUTION: Be careful to avoid pinching

fingers between the back of the mounting plate and

the wall.

Tighten all bolts. Pull the plate away from the wall

to help tighten the bolts.

ATTACH THE MOUNTING PLATE

TO THE WALL

Attach the plate to the wall using toggle bolts.

At least one wood screw must be used to attach

the plate to a wall stud.

Remove the toggle wings from the bolts.

Insert the bolts into the mounting plate through

the holes designated to go into drywall and reattach

the toggle wings to

⁄4″ onto each bolt.

INSTALLATION OVERVIEW

A1. Attach Mounting Plate to Wall

A2. Prepare Top Cabinet

A3. Attach Exhaust Damper

A4. Mount Microwave Oven

Wall

Mounting

Plate

Spacing for Toggles

More Than Wall

Thickness

Bolt End

Toggle

Bolt

Toggle Wings

To use toggle bolts:

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Pas de commentaire

GE JVM2052 Manuel d'utilisateur Page 12