GE JVM2052 Manuel d'utilisateur télécharger pdf (Page 19)

Installation Instructions

USE TOP CABINET TEMPLATE FOR

PREPARATION OF TOP CABINET

RECIRCULATING (Non-Vented Ductless)

INSTALLATION OVERVIEW

C1. Attach Mounting Plate to Wall

C2. Prepare Top Cabinet

C3. Adjust Blower

C4. Mount the Microwave Oven

C5. Install Charcoal Filter

• Read the instructions on the TOP CABINET TEMPLATE.

• Tape it underneath the top cabinet.

• Drill the holes, following the instructions on the TOP

CABINET TEMPLATE.

CAUTION: Wear safety goggles when

drilling holes in the cabinet bottom.

You need to drill holes for the top support screws and

a hole large enough for the power cord to fit through.

Place the mounting plate against the wall and insert

the toggle wings into the holes in the wall to mount

the plate.

NOTE: Before tightening toggle bolts and wood screw,

make sure the tabs on the mounting plate touch

the bottom of the cabinet when pushed flush against

the wall and that the plate is properly centered under

the cabinet.

CAUTION: Be careful to avoid pinching

fingers between the back of the mounting plate and

the wall.

Tighten all bolts. Pull the plate away from the wall

to help tighten the bolts.

ATTACH THE MOUNTING PLATE

TO THE WALL

Attach the plate to the wall using toggle bolts.

At least one wood screw must be used to attach

the plate to a wall stud.

Remove the toggle wings from the bolts.

Insert the bolts into the mounting plate through

the holes designated to go into drywall and

reattach the toggle wings to

⁄4″ onto each bolt.

Wall

Mounting

Plate

Spacing for Toggles

More Than Wall

Thickness

Bolt End

Toggle

Bolt

Toggle Wings

To use toggle bolts:

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

GE JVM2052 Manuel d'utilisateur Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Fours GE JVM2052