GE GXRV10ABL01 Manuel d'utilisateur télécharger pdf (Page 13)

Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions Installation Instructions

Filtration Drain Connection Installations

Check and comply with all state and local plumbing codes as you plan.

CAUTION: The options detailed below are the ONLY approved installation configurations. Do not use any

drain saddle device.

NOTE: Failure to follow these Installation Instructions will void the Warranty, and the Installer will be

responsible for any service, repair or damages caused thereby.

Fig. 3A.

Fig. 3B.

Fig. 3C.

From second sink

or disposer

From second sink

or disposer

From second

sink or disposer

From

faucet

air gap

Drain line from

Reverse Osmosis

by-passing faucet

air gap

Maintain air gap

at drain point in

basement

Drain line adapter

Separate p-trap

Cap (not

included)

4″

Min.

From faucet

air gap

Drain line adapter

Preferred Installation Options

(Options A, B and C)

OPTION A.

BASEMENT ACCESS INSTALLATION (Fig. 3A)

Route the drain line DIRECTLY from the Reverse Osmosis

system to a standpipe in the basement, by-passing the air

gap provided in the faucet. The drain line may also be

routed in the basement to a floor drain or washtub,

provided that the air gap in the basement is maintained.

Avoid dips, loops or low spots in the drain line. The

basement air gap and drain installation configuration

must conform to all local codes. Special air gap fittings

are available to connect the drain line to the top of the

standpipe.

OPTION B.

SEPARATE VENT INSTALLATION—

2 P-TRAP (DRY-VENTED) (Fig. 3B)

Install a separate dry-vented p-trap under the sink to

be used exclusively for the Reverse Osmosis drain line.

A dry-vented p-trap is a p-trap that has its own vent/stack.

Attach the provided drain line adapter to the p-trap and

secure it with the slip joint nut and washer as shown.

Route the drain line from the air gap to the drain line

adapter ensuring that there are no dips, loops or low

spots in the line, which could result in a clogged drain

line. The drain line adapter should be aligned vertically

such that the hose connection points in a direction 45°

off vertical. (See Fig. 3E.) The drain line must be routed

through the air gap provided in the RO water faucet.

OPTION C.

SHARED VENT INSTALLATION—

2 P-TRAP (WET-VENTED) (Fig. 3C)

Install a p-trap under the sink to be used exclusively for

the Reverse Osmosis drain line. A wet-vented p-trap is a

p-trap that shares a common vent/stack. Attach the

provided drain line adapter to the p-trap and secure it

with the slip joint nut and washer as shown. Route the

drain line from the air gap to the drain line adapter

ensuring that there are no dips, loops or low spots in the

line, which could result in a clogged drain line. The drain

line adapter should be aligned vertically such that the

hose connection points in a direction 45° off vertical.

(See Fig. 3E.) The drain line must be routed through the

air gap provided in the RO water faucet. Locate the p-trap

as high as possible (minimum of 4″ above horizontal pipe

from second sink or disposer).

Cap (not

included)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 71 72

Commentaires sur ces manuels

Pas de commentaire

GE GXRV10ABL01 Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Articles sanitaires GE GXRV10ABL01