GE GXSF30H Manuel d'utilisateur télécharger pdf (Page 10)

Installation Instructions

CONNECT TO ELECTRICAL POWER

To gain access to the transformer/power cord

assembly, remove the salt hole cover from the

softener. Unclip the tabs on the rear of the top cover

and rotate the cover upward to remove. DO NOT

PULL OR DISCONNECT WIRING.

• The softener works on 24 volt-60Hz electric

power. The included transformer changes

standard 120-volt AC house power to 24 volts.

Plug the transformer into a 120-volt outlet only.

Be sure the outlet is always live so it can not be

switched off by mistake.

• Replace the top cover.

• Replace the salt hole cover.

PROGRAMMING THE CONTROL

CONTROL SETTINGS REQUIRED upon installation

and after an extended power outage.

NOTES:

• WHEN THE TRANSFORMER IS PLUGGED INTO THE

ELECTRICAL OUTLET, 12:00 PM (flashing), and

PRESENT TIME is displayed. Program the control

as instructed below.

If - - - is flashing, use the UP button to

set the correct model code as follows: F30 for

GXSF30H. If you pass by the correct code number,

use the DOWN button. Then press the MODE

button to accept the correct model.

• A “beep” sounds while pressing buttons for control

programming. One beep signals a change in the

control display. Repeated beeps mean the control

will not accept a change from the button you have

pressed, and you should select another button.

• To program the control, you will use the UP ,

DOWN and MODE buttons.

• Use the MODE button to select the desired control

function.

SET PRESENT TIME OF DAY

1. Press the MODE button until

PRESENT TIME appears in the

display.

2. Press UP or DOWN

button to set. The UP button

advances the time; the DOWN

button moves the time in

reverse.

If the present time is between noon and midnight,

be sure PM shows in the display. If the present

time is between midnight and noon, be sure AM

shows in the display.

NOTE: Each press of an UP or DOWN button

changes the time by one minute. Holding the

button changes the time at a rapid rate.

3. When the present time is correct, press MODE to

accept.

SET WATER HARDNESS NUMBER

1. Press the MODE button until

HARDNESS appears in the

display.

2. Press UP or DOWN button

to set your water hardness number in the

display. DOWN decreases the hardness value.

UP increases the hardness value.

NOTE: Each press of a button changes the display

by 1, between 1 and 25. Above 25, the display

changes 5 at a time (25, 30, 35, etc.). Holding a

button in changes the numbers at a rapid rate.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

GE GXSF30H Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Articles sanitaires GE GXSF30H