GE C2S980 Manuel d'utilisateur télécharger pdf (Page 42)

Operating Instructions

Safety Instructions

Installation

Instructions

Troubleshooting TipsConsumer Support

Installation of the range.

IMPORTANT!

Remove all tape and packaging. Make sure the burners are properly seated and level.

Take the accessory pack out of the oven.

Check to be sure that no range parts have come loose during shipping.

LOCATION GUIDELINES

Do not locate the range where it may be subject to strong drafts. Any openings in the floor or

wall behind the range should be sealed. Make sure the openings around the base of the range

that supply fresh air for combustion and ventilation are not obstructed by carpeting or woodwork.

Your range, like many other household items,

is heavy and can settle into soft floor coverings

such as cushioned vinyl or carpeting. Use care

when moving the range on this type of flooring.

It is recommended that the following simple and

inexpensive instructions be followed to protect

your floor.

The range should be installed on a sheet of plywood

(or similar material). When the floor covering ends at

the front of the range, the area that the range will rest

on should be built up with plywood to the same level

or higher than the floor covering.

This will allow the range to be moved for cleaning

or servicing. Also, make sure your floor covering

will withstand 180°F. (See the Installation Safety

Instructions section.)

Make sure the wall coverings around your range

can withstand the heat generated (up to 200°F)

by the range. (See the Installation Safety Instructions

section.)

TOOLS YOU WILL NEED

■

Phillips and flat-blade screwdrivers

■

Pencil and ruler

■

Two pipe wrenches (one for backup)

■ Open-end or adjustable wrench

■ Nut driver or wrench: 1/4

■ Drill

ADDITIONAL MATERIALS YOU MAY NEED:

■ Gas line shut-off valve

■ Pipe joint sealant or UL-approved pipe thread tape

with Teflon* that resists action of natural and LP gases.

*Teflon: Registered trademark of DuPont

■ Flexible metal appliance connector (1/2 I.D.). A 5-foot

length is recommended for ease of installation but

other lengths are acceptable. Never use an old

connector when installing a new range.

■

Flare union adapter for connection to gas supply

line (3/4 or 1/2 NPT x 1/2 I.D.)

■ Flare union adapter for connection to pressure

regulator on range (1/2 NPT x 1/2 I.D.)

■ Liquid leak detector or soapy water.

■ Lag bolt or 1/2 O.D. Sleeve anchor (for concrete

floors only).

■ Squeeze Connector matching the size of the bracket

opening (on the range back behind the wiring cover)

and the house conduit. Obtain only if replacing the

power cord with conduit.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 63 64

Commentaires sur ces manuels

Pas de commentaire

GE C2S980 Manuel d'utilisateur Page 42

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers GE C2S980