GE JA624RNSS Manuel d'instructions télécharger pdf (Page 13)

13

Not all features are on all models.

Using the clock and timer. GEAppliances.com

To Set the Clock

The clock must be set to the correct time of day

for the automatic oven timing functions to work

properly. The time of day cannot be changed

during a delayed cooking or a delayed self-

cleaning cycle.

Touch the Clock pad twice.

Touch the + or – pads.

If the + or – pads are not touched within one

minute after you touch the Clock pad, the

display reverts to the original setting. If this

happens, touch the Clock pad twice and

reenter the time of day.

Touch the Start/On pad until the time of

day shows in the display. This enters the

time and starts the clock.

To check the time of day when the display is

showing other information, simply touch the

Clock pad. The time of day shows until another

pad is touched.

Clock

Start

On

Make sure the clock is set to the

correct time of day.

Start

On

Timer

The timer is a minute timer only.

The Off pad does not affect

the timer.

To Set the Timer

The timer does not control oven operations.

The maximum setting on the timer is 9 hours

and 59 minutes.

Touch the Timer pad.

Touch the + or – pads until the amount of

time you want shows in the display. The

maximum time that can be entered in

minutes is 59. Times more than 59 minutes

should be changed to hours and minutes.

If you make a mistake, touch the Timer pad and

begin again.

Touch the Start/On pad. The time will start

counting down, although the display does

not change until one minute has passed.

When the timer reaches :00, the control

will beep 3 times followed by one beep

every 6 seconds until the Timer pad is

touched.

To Reset the Timer

If the display is still showing the time remaining,

you may change it by touching the Timer pad,

then touching the + or – pads until the time you

want appears in the display.

If the remaining time is not in the display (clock,

delay start or cooking time are in the display),

recall the remaining time by touching the Timer

pad and then touching the + or – pads to enter

the new time you want.

To Cancel the Timer

End of Cycle Tones

(on some models)

Power Outage

Touch the Timer pad twice.

Clear the tones by pressing the pad of the

function you are using.

If a flashing time is in the display, you have

experienced a power failure. Reset the clock.

To reset the clock, touch the CLOCK pad twice.

Enter the correct time of day by touching the +

or - pads. Touch the START/ON pad.

Timer

Cook

Time

OR

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 87 88

Commentaires sur ces manuels

Pas de commentaire