GE JGBP31 Manuel d'utilisateur télécharger pdf (Page 48)

Before you call for service…

Problem Possible Causes What To Do

Excessive smoking

Excessive soil. • On models with touch pads, touch the

Clear/Off

pad.

On models with an

OVEN TEMP

knob, turn it to OFF.

Open the windows to rid the room of smoke. Wait until

the

SELF CLEAN

light goes off. Wipe up the excess soil

and reset the clean cycle.

Oven door will not open

Oven too hot. • Allow the oven to cool below locking temperature.

after a clean cycle

Oven not clean after

Oven controls not properly set. • See the

Using the self-cleaning oven

section.

a clean cycle

Oven was heavily soiled. • Clean up heavy spillovers before starting the clean cycle.

Heavily soiled ovens may need to self-clean again or for

a longer period of time.

Oven door will not

Oven is too hot. • Allow the oven to cool below locking temperature.

unlock (on models

Do not lock the door with the door latch except when

with a door latch)

using the self-clean feature.

Self clean light (on

The

OVEN TEMP

knob has not •Set the

OVEN TEMP

knob to

CLEAN

. See the

Using the

some models) blinks

been set to

CLEAN

when the

self-cleaning oven

section.

when trying to set a

latch was moved to the right.

self clean cycle

The latch was not moved to the •Move the latch to the right as far as it will go. See the

right when the

OVEN TEMP

knob

Using the self-cleaning oven

section.

was set to

CLEAN

Self clean light (on

A power interruption occurred. •Turn the

OVEN TEMP

knob to

OFF

and move the latch

some models) blinks

to the left as far as it will go. Reset the range controls

during self clean cycle

to the desired settings. See the

Using the self-cleaning

oven

section.

“Door” appears in the

Self-cleaning cycle has been •Move the latch handle all the way to the right.

display

(on some models)

selected but the latch handle

was not moved all the way

to the right.

Latch handle was moved to the • Move the latch handle to the right only when setting

right but a program other than the self-cleaning cycle.

self-cleaning was selected.

“F—and a number or

On models with a door latch, • The latch may have been moved, even if only slightly,

letter” flash in the display

if a function error code appears from the locked position. Make sure the latch is moved

(on some models)

during the self-cleaning cycle, to the right as far as it will go.

check the oven door latch.

You have a function error code. • Touch the

Clear/Off

pad. Allow the oven to cool for

one hour. Put the oven back into operation.

If the function code repeats. • Disconnect all power to the range for 5 minutes

and then reconnect power. If the function error

code repeats, call for service.

Troubleshooting Tips

Operating

Instructions

Safety Instructions

Care and Cleaning

Installation

Instructions

Troubleshooting Tips

Consumer Support

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 54 55 56

Commentaires sur ces manuels

Pas de commentaire

GE JGBP31 Manuel d'utilisateur Page 48

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers GE JGBP31