GE GSM2200VBB Manuel d'installation télécharger pdf (Page 8)

• Install strain relief in the junction box bracket.

• Insert the power cord through the strain relief and

tighten.

• Make sure black, white, and green dishwasher

wires are threaded through the small hole in the

junction box bracket.

• Connect power cord white (or ribbed) to

dishwasher white, black (or smooth) to dishwasher

black and ground to dishwasher green wire. Use

UL listed wire nuts of appropriate size.

• Install junction box cover using the #10 hex head

screw. Be sure wires are not pinched under the

cover.

STEP 5: INSTALL POWER CORD

Skip this step if the dishwasher will be

permanently connected to the house electrical

system or has a factory installed power cord.

In this step you will need the junction box cover and

the #10 x 1/2" hex head screw from the screw kit set

aside in Step 1.

The power cord and connections must comply

with the National Electrical Code, Section 422 and/

or local codes and ordinances. Maximum power

cord length is 6 feet. Power Cord Kit WX09X70910,

available for purchase from an authorized GE

Appliance Dealer, meets these requirements.

Dishwasher Installation

STEP 7:

INSTALL DRAIN HOSE TO

DISHWASHER DRAIN PORT

Skip this step if drain hose has been pre-installed.

In this step you will need the drain hose and clamp

set aside in Step 1.

IMPORTANT – Prevent drain hose damage

and possible leaks. Be careful not to nick or cut

the drain hose.

• Route the small end of the drain hose from the left

side of the dishwasher through the strain relief

attached to the dishwasher frame and toward

the center of the dishwasher as shown in Figures

L and M.

• Place the hose clamp over the small end of the

drain hose.

• Push the small end of the drain hose over the drain

port on the collection chamber making sure it is

fully seated against the hose stop.

• Tighten the hose clamp to at least 15 inch-pounds

of torque.

Figure K

STEP 6: INSTALL 90° ELBOW

• Wrap a 90° elbow with thread seal tape.

• Thead the 90° elbow into the water valve.

• Do not over tighten the elbow; water valve bracket

could bend or the valve tting could break.

• Position the end of the elbow to face the rear of

the dishwasher.

Figure J

White

Ground

Black

Note: Check That Harness Leads Are

Threaded Thru Small Hole in Bracket

06F1847J

Junction

Box Bracket

923-09Z

Strain

Relief

Drain Hose

Figure L

90° Elbow

Fill Hose

Water Valve

Bracket

Red Electrical

Connection

Thread Seal

Tape

06H-1949 Elbow Install

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

GE GSM2200VBB Manuel d'installation Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle GE GSM2200VBB